From mboxrd@z Thu Jan 1 00:00:00 1970 From: Paul Norman Date: Sat, 19 Nov 2011 10:18:49 +0000 Subject: Re: [lm-sensors] Biostar TA880GB+ Motherboard Information Message-Id: <000201cca6a4$a2524610$e6f6d230$@mac.com> List-Id: References: <000001cca684$f7e5ace0$e7b106a0$@mac.com> In-Reply-To: <000001cca684$f7e5ace0$e7b106a0$@mac.com> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org > From: Jean Delvare [mailto:khali@linux-fr.org] > To: Paul Norman > Subject: Re: [lm-sensors] Biostar TA880GB+ Motherboard Information > > chip "acpitz-virtual-0" > > # This is essentially the same as the CPU temperature. > > This could be problematic. If ACPI reads from the same registers as the > IT8712F chip, as these accesses are not synchronized, they could > collide. This is a problem affecting many boards unfortunately, with no > good solution so far. Would disabling it be a good idea then? Also, do you have any suggestions for the k10temp-pci-00c3 temp1 label? > Go to the BIOS and watch the +5V and +12V values. Write down every > different sample you manage to get. The more samples, the better. Then > check the raw values (from sensors -u) for in0 and in1. Write down all > samples as well if there are many. From that we can find out who is who > and the scaling factors. According to the BIOS +12V is at 12.250 with no variation and +5V is at 5.115. I waited for about 2 minutes. Both in0_input and in1_input vary between 2.940 and 2.952. They vary independently, and I only observed in0_input=2.940 under heavy CPU load. I only observed in1_input=2.940 under heavy IO load. _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors