Re: Unable to get u-boot running on i.MX6 SABRE for Smart Devices Eval Board

["Guillaume Fournier" <gfournier@brioconcept.com>]

Fabio,

The ultimate goal is to have a cross-compiler build environment that works for both u-boot and kernel development.  For now, I used Yocto to generate the toolchain (using meta-toolchain as specified in my first post) as described in section 3.4 of the Yocto Project Application Developer's Guide.  Following your lead I did use "bitbake core-image-base" to generate an image and burned core-image-base-imx6dlsabresd.sdcard to an SD card using:
cfimager -f core-image-base-imx6dlsabresd.sdcard -raw -d d

I used cfimager which is a tool that comes with IMX_6DL_6S_MFG_TOOL since I don't have physical access to a linux box.  The board boots up fine but this is not the goal I seek.  I want to get a working cross-compiling toolchain so I can build u-boot and the kernel outside of Yocto.  I understand the subject of this post is therefore a bit misleading since u-boot does boot when using Yocto build output...  It just doesn't when using the cross-compiling toolchain.

As a side note, I have also downloaded fsl-image-multimedia-imx6dlsabresd.sdcard from http://ci.ossystems.com.br/public/fsl-community-bsp/daisy/76/framebuffer/imx6dlsabresd and burned it to an SD card and it too works fine.

Guillaume Fournier, ing.
Concepteur matériel / Hardware Designer
Brioconcept Consulting Inc.
450.681.2779 x2388

-----Original Message-----
From: Fabio Estevam [mailto:festevam@gmail.com] 
Sent: November 4, 2014 7:03 PM
To: Guillaume Fournier
Cc: meta-freescale@yoctoproject.org
Subject: Re: [meta-freescale] Unable to get u-boot running on i.MX6 SABRE for Smart Devices Eval Board

On Tue, Nov 4, 2014 at 8:44 PM, Guillaume Fournier <gfournier@brioconcept.com> wrote:
> Hello,
>
> I am new to Yocto and I am having a hard time getting a basic 
> environment setup.  I have read a lot of documentation but I'm still 
> stock so I'd like to seek your help.
>
> Problem: I can't get u-boot to start on my evaluation board.  No 
> output whatsoever on the UART.
> Board used: i.MX6 Series SABRE for Smart Devices (MCIMX6DL-SDP)

Could you try to flash the .sdcard image directly to the SD card and boot from there? That would be a quicker method.

There are some pre-built .sdcard images available at http://ci.ossystems.com.br/public/fsl-community-bsp/ that you could quickly try.

Regards,

Fabio Estevam