RE: [PATCH] [UPDATED] tsec: Allow Ten Bit Interface to be configurable

["Joe Hamman" <joe.hamman@embeddedspecialties.com>]

Hi Andy,

> >
> > Is any given board going to have at runtime (i.e. not jumper
> > selectable)  both a phy and a tbi (I'm not very familiar with the
> > latter, so I apologize if this is a dumb question).  If not, I'd
> > stick with phy-handle and have something in the phy node to
> > indicate that it's tbi.
> 
> 
> Yes.  That will be the more common case.  The TBI PHYs are connected
> to the MDIO pins of each TSEC.  The TBIPA register defines what
> address it sits on.  It is used to configure non MII-style data
> connections, usually to another PHY.  For instance, to configure a
> TSEC for SGMII, you first configure the attached TBI to communicate
> with the on-chip SERDES.
> 
> While the TBI devices technically all sit on MDIO busses, only the
> TBI PHY connected to the first TSEC will interfere with MDIO
> transactions.  I don't think we need to create nodes for each of the
> TBIs.  They exist as a secondary part of the ethernet controller, and
> their address is only really important to that controller.
> 
> I still think it should just be a property of the ethernet node.  We
> aren't describing the TBI, we're describing a setting for the
> ethernet controller's register.
> 

Like this?  Do we need to have one for each ethernet@xxxxxx?

	ethernet@24000 {
		#address-cells = <1>;
		#size-cells = <0>;
		device_type = "network";
		model = "eTSEC";
		compatible = "gianfar";
		reg = <24000 1000>;
		mac-address = [ 00 E0 0C 00 73 00 ];
		interrupts = <1d 2 1e 2 22 2>;
		interrupt-parent = <&mpic>;
		phy-handle = <&phy1f>;
		tbi-address = <0x1e>;
	};

Joe