From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stephan Linz Date: Mon, 28 Jun 2004 16:05:19 +0200 Subject: [U-Boot-Users] MPC5200: Moving SDRAM init out of board scope In-Reply-To: References: Message-ID: <0406281605190Q.02269@pcj86> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Am Montag, 28. Juni 2004 14:59 schrieb Jonas Mark-r50740: > Hello, > > I am currently porting U-Boot to a new MPC5200 platform (Total5200). To > reduce code duplication I would like to move the Lite5200 / IceCube SDRAM > initialization (sdram_start() and initdram()) from board/icecube/icecube.c > to cpu/mpc5xxx/sdram.c. So two platforms would use the same code base. > > Any objections? Sounds good to me. We plan to build our own MPC5200 board based on IceCube/Lite5200 in the near future and we'll run U-Boot on it. So it will be the third board. Wolfgang, what's your mind? Best Regards, Stephan Linz > > It seems that at least the maintainer of the PM520 board could change his > code rather quickly to use this scheme as well. > > Regards > Mark > > > ------------------------------------------------------- > This SF.Net email sponsored by Black Hat Briefings & Training. > Attend Black Hat Briefings & Training, Las Vegas July 24-29 - > digital self defense, top technical experts, no vendor pitches, > unmatched networking opportunities. Visit www.blackhat.com > _______________________________________________ > U-Boot-Users mailing list > U-Boot-Users at lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/u-boot-users