Re: [PATCH v8 8/8] arm64: dts: qcom: kodiak: Desribe EUD UTMI routing and connector mapping

[Elson Serrao <elson.serrao@oss.qualcomm.com>]

On 9/21/2026 4:37 AM, Konrad Dybcio wrote:
> On 9/13/26 12:53 AM, Elson Serrao wrote:
>> The existing EUD description uses a legacy single-path representation
>> that assumes uniform UTMI routing. This was sufficient for minimal
>> configurations where the USB port operated only in device mode and role
>> switching was not considered.
>>
>> Update the description to explicitly model the topology using eud path
>> child node and add a role-switch declaration to reflect role-dependent
>> UTMI routing. Also on this SoC, the EUD hardware intercepts only the
>> primary UTMI path. So remove the USB endpoint mapping to the secondary
>> controller and associate it with the primary controller.
>>
>> With the intermediate EUD node now in place, update the Kodiak board
>> descriptions to map the USB connector endpoint to the EUD instead of
>> directly to the USB controller, reflecting the intended hardware
>> topology. Enable the EUD by default now that the complete topology is
>> described.
>>
>> Signed-off-by: Elson Serrao <elson.serrao@oss.qualcomm.com>
>> ---
> 
> [...]
> 
>> diff --git a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
>> index f41ad446a39e..b1f1ff6b99e6 100644
>> --- a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
>> +++ b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
>> @@ -98,7 +98,7 @@ port@0 {
>>  					reg = <0>;
>>  
>>  					pmic_glink_hs_in: endpoint {
>> -						remote-endpoint = <&usb_1_dwc3_hs>;
>> +						remote-endpoint = <&eud_con>;
>>  					};
>>  				};
>>  
>> @@ -1530,10 +1530,6 @@ &usb_1 {
>>  	status = "okay";
>>  };
>>  
>> -&usb_1_dwc3_hs {
>> -	remote-endpoint = <&pmic_glink_hs_in>;
>> -};
>> -
>>  &usb_1_hsphy {
>>  	vdda-pll-supply = <&vreg_l10c>;
>>  	vdda18-supply = <&vreg_l1c>;
>> @@ -1573,3 +1569,7 @@ &wifi {
>>  	qcom,calibration-variant = "Fairphone_5";
>>  	status = "okay";
>>  };
>> +
>> +&eud_con {
>> +	remote-endpoint = <&pmic_glink_hs_in>;
>> +};
> 
> Label references should be sorted alphabetically within a file,
> there may be slight deviations because the tooling to enforce
> that is still under development, but let's try to not add more
> 
Ack. I will update this in v9

Thanks
Elson