From: Borsenkow Andrej <Andrej.Borsenkow@mow.siemens.ru>
To: linux-kernel list <linux-kernel@vger.kernel.org>
Subject: Re: 2.4.18-pre9, Iomega Jaz, PPA - endless loop in SCSI recovery thread
Date: 09 Jun 2002 00:58:00 +0400 [thread overview]
Message-ID: <1023569887.13619.9.camel@localhost.localdomain> (raw)
In-Reply-To: <1023569729.13619.6.camel@localhost.localdomain>
Oh, and when I tried to simply switch off Jaz during this loop I got
panic:
kernel panic: scsi_unjam_host
Miscount of number of failed commands
Not sure if it helps very much ...
-andrej
В Вск, 09.06.2002, в 00:55, Andrej Borsenkow написал:
>
> It looks like a media went corrupted so one expects some reasonable
> error message. What happens is I get endless loop in SCSI error recovery
> thread. The only way to clear up situation is to reboot and even then it
> hangs on umount so I have to do SysRq-B. Please, what additional
> information can be provided; I hope I can keep this media intact for
> some time for testing :-)
>
> the kernel is 2.4.18-18mdk based on 2.4.1-pre9.
>
> I am not on lkml so please Cc me. Thank you.
>
> -andrej
>
>
> {pts/0}% cat /proc/scsi/scsi
> Attached devices:
> Host: scsi0 Channel: 00 Id: 04 Lun: 00
> Vendor: iomega Model: jaz 2GB Rev: E.17
> Type: Direct-Access ANSI SCSI revision: 02
> Host: scsi1 Channel: 00 Id: 03 Lun: 00
> Vendor: PHILIPS Model: CDD3610 CD-R/RW Rev: 3.09
> Type: CD-ROM ANSI SCSI revision: 02
> {pts/0}% cat /proc/scsi/ppa/0
> Version : 2.07 (for Linux 2.4.x)
> Parport : parport0
> Mode : EPP 32 bit
> {pts/0}% uname -a
> Linux localhost.localdomain 2.4.18-18mdkcustom #5 Sat Jun 8 23:25:23 MSD
> 2002 i686 unknown
>
> SCSI log:
>
> Jun 8 20:49:59 localhost kernel: Activating command for device 4 (1)
> Jun 8 20:49:59 localhost kernel: Doing sd request, dev = 0x804, block = 944344
> Jun 8 20:49:59 localhost kernel: sda : real dev = /dev/0, block = 944376
> Jun 8 20:49:59 localhost kernel: sda : reading 248/248 512 byte blocks.
> Jun 8 20:49:59 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12892)
> Jun 8 20:49:59 localhost kernel: scsi_dispatch_cmnd (host = 0, channel = 0, target = 4, command = cd8b1e58, buffer = c009e000,
> Jun 8 20:49:59 localhost kernel: bufflen = 126976, done = d2813b7a)
> Jun 8 20:49:59 localhost kernel: queuecommand : routine at d2a2f1e0
> Jun 8 20:49:59 localhost kernel: leaving scsi_dispatch_cmnd()
> Jun 8 20:50:00 localhost kernel: Clearing timer for command cd8b1e00 1
> Jun 8 20:50:00 localhost kernel: Command failed cd8b1e00 2 active=1 busy=1 failed=0
> Jun 8 20:50:00 localhost kernel: bh08:04: old sense key None
> Jun 8 20:50:00 localhost kernel: Non-extended sense class 0 code 0x0
> Jun 8 20:50:00 localhost kernel: Waking error handler thread (-1)
> Jun 8 20:50:00 localhost kernel: Error handler waking up
> Jun 8 20:50:00 localhost kernel: scsi_unjam_host: Checking to see if we need to request sense
> Jun 8 20:50:00 localhost kernel: scsi_unjam_host: Requesting sense for 4
> Jun 8 20:50:00 localhost kernel: Adding timer for command cd8b1e00 at 1000 (d2a12a28)
> Jun 8 20:50:00 localhost kernel: In eh_done cd8b1e00 result:0
> Jun 8 20:50:00 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:00 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2002
> Jun 8 20:50:00 localhost kernel: Sense requested for cd8b1e00 - result 2
> Jun 8 20:50:00 localhost kernel: Info fld=0xe6960, Current bh08:04: sense key Medium Error
> Jun 8 20:50:00 localhost kernel: Additional sense indicates Address mark not found for data field
> Jun 8 20:50:00 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:03 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:03 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:03 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:03 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:06 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:06 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:06 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:06 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:09 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:09 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:09 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:09 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:12 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:12 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:12 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:12 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:15 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:15 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:15 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:15 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:17 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:17 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:17 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:17 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:20 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:20 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:20 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:20 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:23 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:23 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:23 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
> Jun 8 20:50:23 localhost kernel: Adding timer for command cd8b1e00 at 6000 (d2a12a28)
> Jun 8 20:50:26 localhost kernel: In eh_done cd8b1e00 result:2
> Jun 8 20:50:26 localhost kernel: send_eh_cmnd: cd8b1e00 eh_state:2002
> Jun 8 20:50:26 localhost kernel: scsi_send_eh_cmnd: scsi_eh_completed_normally 2001
next prev parent reply other threads:[~2002-06-08 21:00 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2002-06-08 20:55 2.4.18-pre9, Iomega Jaz, PPA - endless loop in SCSI recovery thread Borsenkow Andrej
2002-06-08 20:58 ` Borsenkow Andrej [this message]
-- strict thread matches above, loose matches on Subject: below --
2002-06-08 22:50 Andries.Brouwer
2002-06-09 16:04 ` Borsenkow Andrej
2002-06-09 16:04 ` Borsenkow Andrej
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1023569887.13619.9.camel@localhost.localdomain \
--to=andrej.borsenkow@mow.siemens.ru \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.