Re: [Bluez-users] bt3c_cs time out - no firmware loaded?

[Marcel Holtmann <marcel@rvs.uni-bielefeld.de>]

Hi Krisztian,

> > > I have trouble with the 3COM Cardbus bluetooth card on a Powerbook
> > > Titanium (a powerpc notebook). I patched the 2.4.20 kernel with the
> > > mh-6 patch (and the benh patch which does not collide). I haven't
> > > found any hint on the list yet.
> > >
> > > With a USB bluetooth adapter (hci_usb) everything works fine. I have a
> > > wonderful RFCOMM communication to a Nokia 6310 and I can get on the
> > > internet via GPRS.
> >
> > is this a SMP enabled kernel? The driver have some problems if you run a
> > SMP kernel. Try to disable it.
> No, single processor. powerpc.
> # CONFIG_SMP is not set
> 
> I hope the card itself would work all right; but as far as I can tell the 
> firmware does not get loaded. I hope this is not a powerpc arch problem.

I missed something in your previous mail :(

You're using a Powerbook and the 3Com is currently not supported on the
PowerPC architecture. The Kernel side of the driver should work fine
(not tested), but the bluefw have no code to load the firmware. Take a
look at the mailing list archive for this problem.

Regards

Marcel




-------------------------------------------------------
Enterprise Linux Forum Conference & Expo, June 4-6, 2003, Santa Clara
The only event dedicated to issues related to Linux enterprise solutions
www.enterpriselinuxforum.com

_______________________________________________
Bluez-users mailing list
Bluez-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bluez-users