Re: Status of qlogic tcp/ip (fc0) support

[Mario Giammarco <mgiammarco@virgilio.it>]

Il lun, 2003-12-15 alle 19:19, Andrew Vasquez ha scritto:

> Try the attached patch against 6.06.10 (available from the QLogic
> website).
> 
Thank you very much! It almost works now!
BTW: I checked again qlogic website and I have not found it...
BTW2: About iSCSI. There are several software iscsi initiator and target
for linux (search with google and in sourceforge). I suggest ardis
target and cisco initiator. They are completely software so they run on
every tcp/ip based network. I have tested them on ethernet but they
should run also on fc0. But they are completely software based: they use
fibre channel only like a fast ethernet.

AND NOW the big problem:

I try to ping from qlogic card to mpt-fusion (lsi logic) card and
viceversa.

Hardware works (both cards see my fibre channel hard disks)

All packets are lost (destination host unreachable), route is ok.

On qlogic based host I see in dmesg output:

qla2x00_send_packet: Unable to determine loop id for destination.
qla2200ip: fc0 - Unable to send packet -- Bad error occured!!!
qla2x00_send_packet: Unable to determine loop id for destination.
qla2200ip: fc0 - Unable to send packet -- Bad error occured!!!
qla2x00_send_packet: Unable to determine loop id for destination.
qla2200ip: fc0 - Unable to send packet -- Bad error occured!!!
...
...

I suppose the bug is perhaps in mpt-fusion code because I triggered it
also with two lsi logic cards.

Please tell it to lsi logic developers also!

Thanks again for past and future help!


-- 
Mario Giammarco