From: Jurgen Kramer <gtm.kramer@inter.nl.net>
To: Andrew Morton <akpm@osdl.org>
Cc: linux-kernel@vger.kernel.org
Subject: Re: 2.6.7-mm4
Date: Tue, 29 Jun 2004 19:51:10 +0200 [thread overview]
Message-ID: <1088531469.7921.4.camel@paragon.slim> (raw)
In-Reply-To: <20040629020417.70717ffe.akpm@osdl.org>
On Tue, 2004-06-29 at 11:04, Andrew Morton wrote:
> ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.7/2.6.7-mm4/
>
> - Various fixes and updates
Hmm, I am not sure if my USB EHCI problem should be fixed now but
unfortunately it isn't.
With 2.6.5 I normally see:
USB Universal Host Controller Interface driver v2.2
uhci_hcd 0000:00:1d.0: Intel Corp. 82801EB USB
PCI: Setting latency timer of device 0000:00:1d.0 to 64
uhci_hcd 0000:00:1d.0: irq 16, io base 0000ef00
uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
uhci_hcd 0000:00:1d.1: Intel Corp. 82801EB USB
PCI: Setting latency timer of device 0000:00:1d.1 to 64
uhci_hcd 0000:00:1d.1: irq 19, io base 0000ef20
uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
uhci_hcd 0000:00:1d.2: Intel Corp. 82801EB USB
PCI: Setting latency timer of device 0000:00:1d.2 to 64
uhci_hcd 0000:00:1d.2: irq 18, io base 0000ef40
uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 3
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
uhci_hcd 0000:00:1d.3: Intel Corp. 82801EB USB
PCI: Setting latency timer of device 0000:00:1d.3 to 64
uhci_hcd 0000:00:1d.3: irq 16, io base 0000ef80
uhci_hcd 0000:00:1d.3: new USB bus registered, assigned bus number 4
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 2 ports detected
ehci_hcd 0000:00:1d.7: Intel Corp. 82801EB USB2
PCI: Setting latency timer of device 0000:00:1d.7 to 64
ehci_hcd 0000:00:1d.7: irq 23, pci mem f8809c00
ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 5
PCI: cache line size of 128 is not supported by device 0000:00:1d.7
ehci_hcd 0000:00:1d.7: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29
hub 5-0:1.0: USB hub found
hub 5-0:1.0: 8 ports detected
But with 2.6.7-mm3/mm4:
USB Universal Host Controller Interface driver v2.2
ACPI: PCI interrupt 0000:00:1d.0[A] -> GSI 16 (level, low) -> IRQ 16
uhci_hcd 0000:00:1d.0: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #1
PCI: Setting latency timer of device 0000:00:1d.0 to 64
uhci_hcd 0000:00:1d.0: irq 16, io base 0000ef00
uhci_hcd 0000:00:1d.0: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ACPI: PCI interrupt 0000:00:1d.1[B] -> GSI 19 (level, low) -> IRQ 19
uhci_hcd 0000:00:1d.1: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #2
PCI: Setting latency timer of device 0000:00:1d.1 to 64
uhci_hcd 0000:00:1d.1: irq 19, io base 0000ef20
uhci_hcd 0000:00:1d.1: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
ACPI: PCI interrupt 0000:00:1d.2[C] -> GSI 18 (level, low) -> IRQ 18
uhci_hcd 0000:00:1d.2: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #3
PCI: Setting latency timer of device 0000:00:1d.2 to 64
uhci_hcd 0000:00:1d.2: irq 18, io base 0000ef40
uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 3
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
ACPI: PCI interrupt 0000:00:1d.3[A] -> GSI 16 (level, low) -> IRQ 16
uhci_hcd 0000:00:1d.3: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #4
PCI: Setting latency timer of device 0000:00:1d.3 to 64
uhci_hcd 0000:00:1d.3: irq 16, io base 0000ef80
uhci_hcd 0000:00:1d.3: new USB bus registered, assigned bus number 4
usb 1-1: new full speed USB device using address 2
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 2 ports detected
ACPI: PCI interrupt 0000:00:1d.7[D] -> GSI 23 (level, low) -> IRQ 23
ehci_hcd 0000:00:1d.7: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB2 EHCI
Controller
<snip>
ehci_hcd 0000:00:1d.7: BIOS handoff failed (104, 1010001)
ehci_hcd 0000:00:1d.7: can't reset
ehci_hcd 0000:00:1d.7: init 0000:00:1d.7 fail, -95
ehci_hcd: probe of 0000:00:1d.7 failed with error -95
There's no bus 5. After unplugging the USB2.0 stick (in the not found
bus 5):
irq 23: nobody cared!
[<c0108106>] __report_bad_irq+0x2a/0x8b
[<c01081f0>] note_interrupt+0x6f/0x9f
[<c0108473>] do_IRQ+0x10c/0x10e
[<c0106850>] common_interrupt+0x18/0x20
[<c010401e>] default_idle+0x0/0x2c
[<c0104047>] default_idle+0x29/0x2c
[<c01040b0>] cpu_idle+0x33/0x3c
[<c031684b>] start_kernel+0x1a0/0x1dd
[<c0316309>] unknown_bootoption+0x0/0x149
handlers:
[<f8aa165c>] (snd_emu10k1_interrupt+0x0/0x3c4 [snd_emu10k1])
Disabling IRQ #23
Jurgen
next prev parent reply other threads:[~2004-06-29 17:41 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2004-06-29 9:04 2.6.7-mm4 Andrew Morton
2004-06-29 17:51 ` Jurgen Kramer [this message]
2004-06-29 17:51 ` 2.6.7-mm4 (compile stats) John Cherry
2004-06-30 7:14 ` 2.6.7-mm4 Danny ter Haar
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1088531469.7921.4.camel@paragon.slim \
--to=gtm.kramer@inter.nl.net \
--cc=akpm@osdl.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.