From: Matthias Hentges <oe@hentges.net>
To: Stephen Hemminger <shemminger@osdl.org>
Cc: Jeff Garzik <jeff@garzik.org>, Andrew Morton <akpm@osdl.org>,
Linux Kernel <linux-kernel@vger.kernel.org>,
Netdev List <netdev@vger.kernel.org>
Subject: Re: sky2 (was Re: 2.6.18-mm2)
Date: Sun, 08 Oct 2006 19:00:01 +0200 [thread overview]
Message-ID: <1160326801.4575.27.camel@mhcln03> (raw)
In-Reply-To: <20061008092001.0c83a359@localhost.localdomain>
[-- Attachment #1.1: Type: text/plain, Size: 1191 bytes --]
Am Sonntag, den 08.10.2006, 09:20 -0700 schrieb Stephen Hemminger:
> On Sun, 08 Oct 2006 15:41:45 +0200
> Matthias Hentges <oe@hentges.net> wrote:
[...]
> > I have verified this behavior (works fine w/o debug patch, freezes with
> > patch applied) with:
> > - 2.6.19-rc1-git4
> > - 2.6.18-git something
> > - 2.6.18-mm3
> >
>
> Does 2.6.18 work?
2.6.18 does not require the patch ( in fact, the patch won't apply at
all) and thus does not freeze when the NIC goes down.
> What is the PCI config of the device (lspci -vvvx)?
I've attached the lspci dump of both onboard sky2 NICs.
> What is the chip version (dmesg | grep sky2)?
>
+root@mhcln01:..patches/generic/coretemp >dmesg |grep sky2
[ 34.833453] sky2 v1.7 addr 0xfa9fc000 irq 17 Yukon-EC (0xb6) rev 2
[ 34.833527] sky2 eth0: addr 00:17:31:f4:f1:8c
[ 34.833663] sky2 v1.7 addr 0xfa8fc000 irq 16 Yukon-EC (0xb6) rev 2
[ 34.833729] sky2 eth1: addr 00:17:31:f4:f7:cc
[ 42.165687] sky2 eth1: enabling interface
[ 43.847972] sky2 eth1: Link is up at 100 Mbps, full duplex, flow
control both
--
Matthias 'CoreDump' Hentges
My OS: Debian SID. Geek by Nature, Linux by Choice
[-- Attachment #1.2: lspci-vvvv_sky2-1.txt --]
[-- Type: text/plain, Size: 1533 bytes --]
03:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 20)
Subsystem: ASUSTeK Computer Inc. Marvell 88E8053 Gigabit Ethernet controller PCIe (Asus)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0, Cache Line Size: 16 bytes
Interrupt: pin A routed to IRQ 216
Region 0: Memory at fa8fc000 (64-bit, non-prefetchable) [size=16K]
Region 2: I/O ports at a800 [size=256]
Expansion ROM at fa8c0000 [disabled] [size=128K]
Capabilities: [48] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] Vital Product Data
Capabilities: [5c] Message Signalled Interrupts: Mask- 64bit+ Queue=0/1 Enable+
Address: 00000000fee0100c Data: 4152
Capabilities: [e0] Express Legacy Endpoint IRQ 0
Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag-
Device: Latency L0s unlimited, L1 unlimited
Device: AtnBtn- AtnInd- PwrInd-
Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
Device: MaxPayload 128 bytes, MaxReadReq 512 bytes
Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s, Port 0
Link: Latency L0s <256ns, L1 unlimited
Link: ASPM Disabled RCB 128 bytes CommClk+ ExtSynch-
Link: Speed 2.5Gb/s, Width x1
[-- Attachment #1.3: lspci-vvvv_sky2-2.txt --]
[-- Type: text/plain, Size: 1533 bytes --]
04:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 20)
Subsystem: ASUSTeK Computer Inc. Marvell 88E8053 Gigabit Ethernet controller PCIe (Asus)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 0, Cache Line Size: 16 bytes
Interrupt: pin A routed to IRQ 217
Region 0: Memory at fa9fc000 (64-bit, non-prefetchable) [size=16K]
Region 2: I/O ports at b800 [size=256]
Expansion ROM at fa9c0000 [disabled] [size=128K]
Capabilities: [48] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] Vital Product Data
Capabilities: [5c] Message Signalled Interrupts: Mask- 64bit+ Queue=0/1 Enable+
Address: 00000000fee0300c Data: 414a
Capabilities: [e0] Express Legacy Endpoint IRQ 0
Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag-
Device: Latency L0s unlimited, L1 unlimited
Device: AtnBtn- AtnInd- PwrInd-
Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop-
Device: MaxPayload 128 bytes, MaxReadReq 512 bytes
Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s, Port 0
Link: Latency L0s <256ns, L1 unlimited
Link: ASPM Disabled RCB 128 bytes CommClk+ ExtSynch-
Link: Speed 2.5Gb/s, Width x1
[-- Attachment #2: Dies ist ein digital signierter Nachrichtenteil --]
[-- Type: application/pgp-signature, Size: 189 bytes --]
next prev parent reply other threads:[~2006-10-08 17:00 UTC|newest]
Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <20060928155053.7d8567ae.akpm@osdl.org>
2006-09-28 23:07 ` sky2 (was Re: 2.6.18-mm2) Jeff Garzik
2006-09-28 23:19 ` Stephen Hemminger
2006-09-30 0:26 ` Matthias Hentges
2006-10-04 2:57 ` Matthias Hentges
2006-10-04 3:26 ` Stephen Hemminger
2006-10-07 19:48 ` Matthias Hentges
2006-10-08 13:41 ` Matthias Hentges
2006-10-08 16:20 ` Stephen Hemminger
2006-10-08 17:00 ` Matthias Hentges [this message]
2006-10-08 18:31 ` Matthias Hentges
2006-10-09 16:45 ` Stephen Hemminger
2006-10-09 23:14 ` Oleg Verych
2006-10-15 4:27 ` Oleg Verych
2006-10-10 10:45 ` Matthias Hentges
2006-10-10 0:02 ` Beber
2006-09-28 23:25 ` Andrew Morton
2006-09-28 23:30 ` Stephen Hemminger
2006-09-29 16:04 ` Andrea Gelmini
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1160326801.4575.27.camel@mhcln03 \
--to=oe@hentges.net \
--cc=akpm@osdl.org \
--cc=jeff@garzik.org \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=shemminger@osdl.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.