Re: [PATCH net] net/ipv6: Only update MTU metric if it set

[Jan Janssen <medhefgo@web.de>]

On Donnerstag, 30. August 2018 23:15:43 CEST dsahern@kernel.org wrote:
> From: David Ahern <dsahern@gmail.com>
> 
> Jan reported a regression after an update to 4.18.5. In this case ipv6
> default route is setup by systemd-networkd based on data from an RA. The
> RA contains an MTU of 1492 which is used when the route is first inserted
> but then systemd-networkd pushes down updates to the default route
> without the mtu set.
> 
> Prior to the change to fib6_info, metrics such as MTU were held in the
> dst_entry and rt6i_pmtu in rt6_info contained an update to the mtu if
> any. ip6_mtu would look at rt6i_pmtu first and use it if set. If not,
> the value from the metrics is used if it is set and finally falling
> back to the idev value.
> 
> After the fib6_info change metrics are contained in the fib6_info struct
> and there is no equivalent to rt6i_pmtu. To maintain consistency with
> the old behavior the new code should only reset the MTU in the metrics
> if the route update has it set.
> 
> Fixes: d4ead6b34b67 ("net/ipv6: move metrics from dst to rt6_info")
> Reported-by: Jan Janssen <medhefgo@web.de>
> Signed-off-by: David Ahern <dsahern@gmail.com>
> ---
>  net/ipv6/ip6_fib.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
> 
> diff --git a/net/ipv6/ip6_fib.c b/net/ipv6/ip6_fib.c
> index d212738e9d10..f43d278e0040 100644
> --- a/net/ipv6/ip6_fib.c
> +++ b/net/ipv6/ip6_fib.c
> @@ -987,7 +987,10 @@ static int fib6_add_rt2node(struct fib6_node *fn,
> struct fib6_info *rt, fib6_clean_expires(iter);
>  				else
>  					fib6_set_expires(iter, rt->expires);
> -				fib6_metric_set(iter, RTAX_MTU, rt->fib6_pmtu);
> +
> +				if (rt->fib6_pmtu)
> +					fib6_metric_set(iter, RTAX_MTU,
> +							rt->fib6_pmtu);
>  				return -EEXIST;
>  			}
>  			/* If we have the same destination and the same metric,

I just tested this and can confirm that it fixes my problem.

You mentioned that systemd-networkd is doing something silly here, so I was 
wondering if you could make a bug report to fix the underlying issue? I don't 
mind doing it myself but you're the expert and can explain things better.

Thank you for fixing this.