From: Vivek Berodhia <vivek.berodhia@domain.hid>
To: xenomai@xenomai.org
Subject: [Xenomai-help] Unhandled irq 33
Date: Sat, 05 Jul 2008 15:17:48 +0530 [thread overview]
Message-ID: <1215251268.3029.13.camel@domain.hid> (raw)
Dear All,
Help me,
I am facing a problem during booting with xenomai kernel "unhandled
irq33".
Kernel Configuration.
ARCH= powerpc
CROSS_COMPILE=gcc-6xx-
target machine = mpc8323
following is serial port capture of problem..please help me..
TFTP from server 192.168.4.51; our IP address is 192.168.4.251
Filename 'uImage'.
Load address: 0x200000
Loading:
#################################################################
################################################
done
Bytes transferred = 1658616 (194ef8 hex)
Using FSL UEC0 device
TFTP from server 192.168.4.51; our IP address is 192.168.4.251
Filename 'my.dtb'.
Load address: 0x400000
Loading: #
done
Bytes transferred = 8192 (2000 hex)
## Booting image at 00200000 ...
Image Name: Linux-2.6.24.2
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 1658552 Bytes = 1.6 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Booting using the fdt at 0x400000
WARNING: could not set linux,stdout-path FDT_ERR_NOTFOUND.
Using MPC832x RDB machine description
Linux version 2.6.24.2 (root@domain.hid) (gcc version 4.2.2) #1
Sat Jul 5
11:10:57 IST 2008
console [udbg0] enabled
setup_arch: bootmem
mpc832x_rdb_setup_arch()
Found MPC83xx PCI host bridge at 0x00000000e0008500. Firmware
bus
number: 0->0
arch: exit
Zone PFN ranges:
DMA 0 -> 16384
Normal 16384 -> 16384
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0 -> 16384
Built 1 zonelists in Zone order, mobility grouping on. Total
pages:
16256
Kernel command line: nfsroot=192.168.4.51:/opt/eldk/nfs2
ip=192.168.4.251:192.168.4.51:192.168.4.254:255.255.255.0:Coral_Router:eth1:off root=0
IPIC (128 IRQ sources) at fdefb700
PID hash table entries: 256 (order: 8, 1024 bytes)
clocksource: timebase mult[7800001] shift[22] registered
I-pipe 2.1-00: pipeline enabled.
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 61120k/65536k available (3344k kernel code, 4356k
reserved, 152k
data, 238k bss, 148k init)
SLUB: Genslabs=11, HWalign=32, Order=0-1, MinObjects=4, CPUs=1,
Nodes=1
Mount-cache hash table entries: 512
device-tree: Duplicate name in /, renamed to "chosen#1"
net_namespace: 64 bytes
NET: Registered protocol family 16
PCI: Probing PCI hardware
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Time: timebase clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
I-pipe: Domain Xenomai registered.
Xenomai: hal/powerpc started.
Xenomai: real-time nucleus v2.4.2 (One Big Rush) loaded.
Xenomai: starting native API services.
Xenomai: starting POSIX services.
Xenomai: starting RTDM services.
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
Generic RTC Driver v1.07
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing
disabled
serial8250.0: ttyS0 at MMIO 0xe0004500 (irq = 18) is a 16550A
console handover: boot [udbg0] -> real [ttyS0]
serial8250.0: ttyS1 at MMIO 0xe0004600 (irq = 19) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 32768K size 1024
blocksize
loop: module loaded
Intel(R) PRO/1000 Network Driver - version 7.3.20-k2
Copyright (c) 1999-2006 Intel Corporation.
UCC Ethernet Controller MII Bus: probed
ucc_geth: QE UCC Gigabit Ethernet Controller
Driver 'sd' needs updating - please use bus_type methods
mpc83xx_spi.1: MPC83xx SPI Controller driver at 0xc50084c0 (irq
= 20)
usbmon: debugfs is not available
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
i2c /dev entries driver
WDT driver for MPC83xx initialized. mode:reset timeout=65535 (32
seconds)
mmc_spi spi1216.0: SD/MMC host mmc0, no DMA, no WP, no poweroff
TCP cubic registered
irq 33, desc: c034cf04, depth: 0, count: 0, unhandled: 0
irq 33, desc: c034cf04, depth: 0, count: 0, unhandled: 0
->handle_irq(): c0019c0c, ->chip(): c03ae368, ->action():
00000000
IRQ_LEVEL set
IRQ_NOPROBE set
IRQ_NOREQUEST set
illegal vector 33 received!
------------[ cut here ]------------
Kernel BUG at c00504b0 [verbose debug info unavailable]
Oops: Exception in kernel mode, sig: 5 [#1]
MPC832x RDB
Modules linked in:
NIP: c00504b0 LR: c00504b0 CTR: c01a0c04
REGS: c3935a30 TRAP: 0700 Not tainted (2.6.24.2)
MSR: 00021032 <ME,IR,DR> CR: 24222024 XER: 00000000
TASK = c385c7a0[761] 'mpc83xx_spi.1' THREAD: c3934000
GPR00: c00504b0 c3935ae0 c385c7a0 0000001f 00001267 ffffffff
c01a30f0
00004000
GPR08: 00000001 c0354f70 00000003 c0350000 44222022 fffffd7f
03ffd000
00800000
GPR16: ffffffff 80000000 c0370000 c0370000 c0380d20 c0380d44
c0380d40
fffffffd
GPR24: 00000000 c0369b04 000004a0 00000420 c0385484 00000021
c02db248
c034cf04
Call Trace:
[c3935ae0] [c00504b0] (unreliable)
[c3935b00] [c00515e8]
[c3935b10] [c00094e4]
[c3935b20] [c0009820]
[c3935b50] [c0009a98]
[c3935b60] [c0011630]
--- Exception: 501[c3935c20] [0000114a] (unreliable)
[c3935c70] [c0053a74]
[c3935c80] [c0028108]
[c3935d00] [c0028328]
[c3935d50] [c00503c8]
[c3935d70] [c00515e8]
[c3935d80] [c00094e4]
[c3935d90] [c0009820]
[c3935dc0] [c0009a98]
[c3935dd0] [c0011630]
--- Exception: 501[c3935e90] [fffffd7f] (unreliable)
[c3935ea0] [c02a8a7c]
[c3935ee0] [c01e0200]
[c3935f00] [c01dfbec]
[c3935f50] [c0039e0c]
[c3935f90] [c003a0f8]
[c3935fd0] [c003e738]
[c3935ff0] [c0010b1c]
Instruction dump:
3d20c037 57ab103a 392954d8 3c60c02e 7d6b4a14 7fa4eb78 396b0040
3863b2f8
812b0008 39290001 912b0008 4bfd7de1 <0fe00000> 48000000 3c80c02e
7fc3f378
---[ end trace e55df3d7b6b0ab0d ]---
next reply other threads:[~2008-07-05 9:47 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-07-05 9:47 Vivek Berodhia [this message]
2008-07-05 10:26 ` [Xenomai-help] Unhandled irq 33 Philippe Gerum
2008-07-08 10:42 ` Vivek Berodhia
2008-07-17 9:32 ` Vivek Berodhia
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1215251268.3029.13.camel@domain.hid \
--to=vivek.berodhia@domain.hid \
--cc=xenomai@xenomai.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.