All of lore.kernel.org
 help / color / mirror / Atom feed
From: Tejun Heo <tj@kernel.org>
To: jeff@garzik.org, linux-ide@vger.kernel.org
Cc: Tejun Heo <tj@kernel.org>
Subject: [PATCH 5/8] libata: add @spd_limit to sata_down_spd_limit()
Date: Thu, 29 Jan 2009 20:31:33 +0900	[thread overview]
Message-ID: <1233228696-10562-6-git-send-email-tj@kernel.org> (raw)
In-Reply-To: <1233228696-10562-1-git-send-email-tj@kernel.org>

Add @spd_limit to sata_down_spd_limit() so that the caller can specify
the SPD limit it wants.  This parameter doesn't get in the way even
when it's too low.  The closest possible limit is applied.

Signed-off-by: Tejun Heo <tj@kernel.org>
---
 drivers/ata/libata-core.c |   25 ++++++++++++++++++++-----
 drivers/ata/libata-eh.c   |   10 +++++-----
 drivers/ata/libata-pmp.c  |    2 +-
 drivers/ata/libata.h      |    2 +-
 4 files changed, 27 insertions(+), 12 deletions(-)

diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
index 6a5b8e2..0cc0d8f 100644
--- a/drivers/ata/libata-core.c
+++ b/drivers/ata/libata-core.c
@@ -2777,7 +2777,7 @@ int ata_bus_probe(struct ata_port *ap)
 			/* This is the last chance, better to slow
 			 * down than lose it.
 			 */
-			sata_down_spd_limit(&ap->link);
+			sata_down_spd_limit(&ap->link, 0);
 			ata_down_xfermask_limit(dev, ATA_DNXFER_PIO);
 		}
 	}
@@ -2873,21 +2873,27 @@ void ata_port_disable(struct ata_port *ap)
 /**
  *	sata_down_spd_limit - adjust SATA spd limit downward
  *	@link: Link to adjust SATA spd limit for
+ *	@spd_limit: Additional limit
  *
  *	Adjust SATA spd limit of @link downward.  Note that this
  *	function only adjusts the limit.  The change must be applied
  *	using sata_set_spd().
  *
+ *	If @spd_limit is non-zero, the speed is limited to equal to or
+ *	lower than @spd_limit if such speed is supported.  If
+ *	@spd_limit is slower than any supported speed, only the lowest
+ *	supported speed is allowed.
+ *
  *	LOCKING:
  *	Inherited from caller.
  *
  *	RETURNS:
  *	0 on success, negative errno on failure
  */
-int sata_down_spd_limit(struct ata_link *link)
+int sata_down_spd_limit(struct ata_link *link, u32 spd_limit)
 {
 	u32 sstatus, spd, mask;
-	int rc, highbit;
+	int rc, bit;
 
 	if (!sata_scr_valid(link))
 		return -EOPNOTSUPP;
@@ -2906,8 +2912,8 @@ int sata_down_spd_limit(struct ata_link *link)
 		return -EINVAL;
 
 	/* unconditionally mask off the highest bit */
-	highbit = fls(mask) - 1;
-	mask &= ~(1 << highbit);
+	bit = fls(mask) - 1;
+	mask &= ~(1 << bit);
 
 	/* Mask off all speeds higher than or equal to the current
 	 * one.  Force 1.5Gbps if current SPD is not available.
@@ -2921,6 +2927,15 @@ int sata_down_spd_limit(struct ata_link *link)
 	if (!mask)
 		return -EINVAL;
 
+	if (spd_limit) {
+		if (mask & ((1 << spd_limit) - 1))
+			mask &= (1 << spd_limit) - 1;
+		else {
+			bit = ffs(mask) - 1;
+			mask = 1 << bit;
+		}
+	}
+
 	link->sata_spd_limit = mask;
 
 	ata_link_printk(link, KERN_WARNING, "limiting SATA link speed to %s\n",
diff --git a/drivers/ata/libata-eh.c b/drivers/ata/libata-eh.c
index 90092c1..685509b 100644
--- a/drivers/ata/libata-eh.c
+++ b/drivers/ata/libata-eh.c
@@ -1875,7 +1875,7 @@ static unsigned int ata_eh_speed_down(struct ata_device *dev,
 	/* speed down? */
 	if (verdict & ATA_EH_SPDN_SPEED_DOWN) {
 		/* speed down SATA link speed if possible */
-		if (sata_down_spd_limit(link) == 0) {
+		if (sata_down_spd_limit(link, 0) == 0) {
 			action |= ATA_EH_RESET;
 			goto done;
 		}
@@ -2627,11 +2627,11 @@ int ata_eh_reset(struct ata_link *link, int classify,
 	}
 
 	if (try == max_tries - 1) {
-		sata_down_spd_limit(link);
+		sata_down_spd_limit(link, 0);
 		if (slave)
-			sata_down_spd_limit(slave);
+			sata_down_spd_limit(slave, 0);
 	} else if (rc == -EPIPE)
-		sata_down_spd_limit(failed_link);
+		sata_down_spd_limit(failed_link, 0);
 
 	if (hardreset)
 		reset = hardreset;
@@ -3011,7 +3011,7 @@ static int ata_eh_handle_dev_fail(struct ata_device *dev, int err)
 			/* This is the last chance, better to slow
 			 * down than lose it.
 			 */
-			sata_down_spd_limit(ata_dev_phys_link(dev));
+			sata_down_spd_limit(ata_dev_phys_link(dev), 0);
 			if (dev->pio_mode > XFER_PIO_0)
 				ata_down_xfermask_limit(dev, ATA_DNXFER_PIO);
 		}
diff --git a/drivers/ata/libata-pmp.c b/drivers/ata/libata-pmp.c
index 98ca07a..619f2c3 100644
--- a/drivers/ata/libata-pmp.c
+++ b/drivers/ata/libata-pmp.c
@@ -729,7 +729,7 @@ static int sata_pmp_eh_recover_pmp(struct ata_port *ap,
 		if (tries) {
 			/* consecutive revalidation failures? speed down */
 			if (reval_failed)
-				sata_down_spd_limit(link);
+				sata_down_spd_limit(link, 0);
 			else
 				reval_failed = 1;
 
diff --git a/drivers/ata/libata.h b/drivers/ata/libata.h
index 0a6f5be..cea8014 100644
--- a/drivers/ata/libata.h
+++ b/drivers/ata/libata.h
@@ -99,7 +99,7 @@ extern int ata_dev_reread_id(struct ata_device *dev, unsigned int readid_flags);
 extern int ata_dev_revalidate(struct ata_device *dev, unsigned int new_class,
 			      unsigned int readid_flags);
 extern int ata_dev_configure(struct ata_device *dev);
-extern int sata_down_spd_limit(struct ata_link *link);
+extern int sata_down_spd_limit(struct ata_link *link, u32 spd_limit);
 extern int ata_down_xfermask_limit(struct ata_device *dev, unsigned int sel);
 extern void ata_sg_clean(struct ata_queued_cmd *qc);
 extern void ata_qc_free(struct ata_queued_cmd *qc);
-- 
1.6.0.2


  parent reply	other threads:[~2009-01-29 11:32 UTC|newest]

Thread overview: 13+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2009-01-29 11:31 [PATCHSET #upstream-fixes] libata: improve flaky link handling Tejun Heo
2009-01-29 11:31 ` [PATCH 1/8] libata: fix EH device failure handling Tejun Heo
2009-01-29 11:31 ` [PATCH 2/8] libata: move ata_dev_disable() to libata-eh.c Tejun Heo
2009-01-29 11:31 ` [PATCH 3/8] libata: check onlineness before using SPD in sata_down_spd_limit() Tejun Heo
2009-01-29 11:31 ` [PATCH 4/8] libata: clear dev->ering in smarter way Tejun Heo
2009-01-29 11:31 ` Tejun Heo [this message]
2009-01-29 11:31 ` [PATCH 6/8] libata: improve probe failure handling Tejun Heo
2009-01-29 11:31 ` [PATCH 7/8] libata: add no penalty retry request for EH device handling routines Tejun Heo
2009-01-29 11:31 ` [PATCH 8/8] libata: implement HORKAGE_1_5_GBPS and apply it to WD My Book Tejun Heo
2009-02-03  4:04   ` Jeff Garzik
2009-01-29 14:07 ` [PATCHSET #upstream-fixes] libata: improve flaky link handling Greg Freemyer
2009-01-29 15:50   ` Mark Lord
2009-01-29 23:57     ` Tejun Heo

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1233228696-10562-6-git-send-email-tj@kernel.org \
    --to=tj@kernel.org \
    --cc=jeff@garzik.org \
    --cc=linux-ide@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.