Re: Why analog loopback of sigmatel devices got removed?

[Maxim Levitsky <maximlevitsky@gmail.com>]

On Fri, 2009-06-19 at 20:44 +0200, Takashi Iwai wrote:
> At Fri, 19 Jun 2009 21:18:49 +0300,
> Maxim Levitsky wrote:
> > 
> > On Fri, 2009-06-19 at 08:32 +0200, Takashi Iwai wrote:
> > > echo "loopback yes" > /sys/class/sound/hwC0D0/hints
> > 
> > 
> > This is unmerged  feature?
> > 
> > root@MAIN:/home/maxim# cat /sys/class/sound/hwC0D2/
> > dev        device/    power/     subsystem/ uevent     
> > 
> > 
> > I use -git of the kernel
> 
> Set CONFIG_SND_HDA_RECONFIG=y.
> 
> 
> Takashi

Ok, I see it now, but  then I put these commands in /etc/rc.local



echo  "loopback=yes" > /sys/class/sound/hwC0D2/hints
echo 1 > /sys/class/sound/hwC0D2/reconfig


and I get this, and almost empty mixer


[   57.353168] hda-codec: reconfiguring
[   57.426105] stac92xx_auto_fill_dac_nids: No available DAC for pin 0xd
[   59.121418] e1000e 0000:00:19.0: irq 29 for MSI/MSI-X
[   59.172115] e1000e 0000:00:19.0: irq 29 for MSI/MSI-X
[   60.585005] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow
Control: RX/TX
[   60.585011] 0000:00:19.0: eth0: 10/100 speed: disabling TSO



I had to reload the driver and apply the above commands to make it and
loopback work...


Why? It all did work fine before.


Regards,
	Maxim Levitsky