From mboxrd@z Thu Jan 1 00:00:00 1970 Received: from mail.emacinc.com ([63.245.244.68]) by linuxtogo.org with esmtp (Exim 4.69) (envelope-from ) id 1Nck3i-0004hf-5w for openembedded-devel@lists.openembedded.org; Wed, 03 Feb 2010 19:34:41 +0100 Received: from [63.245.244.67] (helo=emac081.emacinc.com) by mail.emacinc.com with esmtp (Exim 4.50) id 1Nck19-0001Gf-L3 for openembedded-devel@lists.openembedded.org; Wed, 03 Feb 2010 12:32:06 -0600 From: Travis Stratman To: OE dev list Date: Wed, 03 Feb 2010 12:31:54 -0600 Message-Id: <1265221914.4267.273.camel@cheeto.emacinc.com> Mime-Version: 1.0 X-Mailer: Evolution 2.6.3 X-SA-Exim-Connect-IP: 63.245.244.68 X-SA-Exim-Mail-From: tstratman@emacinc.com X-SA-Exim-Version: 4.2.1 (built Wed, 25 Jun 2008 17:20:07 +0000) X-SA-Exim-Scanned: No (on linuxtogo.org); Unknown failure Subject: re-run install task without cleaning X-BeenThere: openembedded-devel@lists.openembedded.org X-Mailman-Version: 2.1.11 Precedence: list Reply-To: openembedded-devel@lists.openembedded.org List-Id: Using the OpenEmbedded metadata to build Distributions List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , X-List-Received-Date: Wed, 03 Feb 2010 18:34:41 -0000 Content-Type: text/plain Content-Transfer-Encoding: 7bit Hello, I have been working with Qt embedded and I want to make a subtle change to the bitbake script that will only affect the install task (which now completes successfully). Normally when I do something like this I just clean and build the whole thing over again to get bitbake to use the new install task. Just doing a '-c install' won't work because the previous build completed successfully. Because Qt takes about 2 hours to compile, I'm hoping that there is some trick that I am not aware of where I can change and re-run the install task (and all subsequent tasks) without rebuilding the whole package. Any suggestions? Thanks, TAS