From mboxrd@z Thu Jan 1 00:00:00 1970 From: Philippe Gerum In-Reply-To: <4CA8D713.8090900@domain.hid> References: <4CA8D713.8090900@domain.hid> Content-Type: text/plain; charset="UTF-8" Date: Thu, 07 Oct 2010 16:33:38 +0200 Message-ID: <1286462018.13186.44.camel@domain.hid> Mime-Version: 1.0 Content-Transfer-Encoding: 7bit Subject: Re: [Adeos-main] Problem with dm9000 and adeos-ipipe-2.6.34-blackfin-1.14-02.patch List-Id: General discussion about Adeos List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , To: Javier Herrero Cc: adeos-main@gna.org On Sun, 2010-10-03 at 21:18 +0200, Javier Herrero wrote: > Hello, > > I'm trying adeos on a Blackfin BF532 board with a DM9000 ethernet > interface. If ethernet is down (cable disconnected) the system boots and > works OK, but as soon as the ethernet cable is plugged, the system > apparently hangs. After several seconds, a message dm9000 dm9000.0: > status check fail: 226 appears. > > I've read a previous post about problems with dm9000 and an ARM > processor, > https://mail.gna.org/public/xenomai-help/2010-03/msg00147.html but it > seems that there was not a response. > dm9000 is probably not the important issue, what makes a difference is which kind of IRQ is handled by this device. Knowing about the output of /proc/interrupts when the pipeline is disabled would help. You may want to upgrade to this patch as well: http://download.gna.org/adeos/patches/v2.6/blackfin/older/adeos-ipipe-2.6.34-blackfin-1.15-01.patch > Thank you very much. Best regards, > > Javier > -- Philippe.