[PATCH net-2.6] atl1c: Fix hardware type check for enabling OTP CLK

[Ben Hutchings <ben@decadent.org.uk>]

Commit 496c185c9495629ef1c65387cb2594578393cfe0 "atl1c: Add support
for Atheros AR8152 and AR8152" added the condition:

             if (hw->nic_type == athr_l1c || hw->nic_type == athr_l2c_b)

for enabling OTP CLK, and the condition:

             if (hw->nic_type == athr_l1c || hw->nic_type == athr_l2c)

for disabling OTP CLK.  Since the two previously defined hardware
types are athr_l1c and athr_l2c, the latter condition appears to be
the correct one.  Change the former to match.

Signed-off-by: Ben Hutchings <ben@decadent.org.uk>
---
This is compile-tested only.  It looks like the current code may fail to
read non-volatile settings on the L2C hardware since the EEPROM will not
be clocked.  Please check this.

Ben.

 drivers/net/atl1c/atl1c_hw.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/net/atl1c/atl1c_hw.c b/drivers/net/atl1c/atl1c_hw.c
index 919080b..1bf6720 100644
--- a/drivers/net/atl1c/atl1c_hw.c
+++ b/drivers/net/atl1c/atl1c_hw.c
@@ -82,7 +82,7 @@ static int atl1c_get_permanent_address(struct atl1c_hw *hw)
 	addr[0] = addr[1] = 0;
 	AT_READ_REG(hw, REG_OTP_CTRL, &otp_ctrl_data);
 	if (atl1c_check_eeprom_exist(hw)) {
-		if (hw->nic_type == athr_l1c || hw->nic_type == athr_l2c_b) {
+		if (hw->nic_type == athr_l1c || hw->nic_type == athr_l2c) {
 			/* Enable OTP CLK */
 			if (!(otp_ctrl_data & OTP_CTRL_CLK_EN)) {
 				otp_ctrl_data |= OTP_CTRL_CLK_EN;
-- 
1.7.2.3