Re: [PATCH 4/5] ethtool: Use the full 32 bit speed range in ethtool's set_settings

[Ben Hutchings <bhutchings@solarflare.com>]

On Sat, 2011-04-16 at 17:54 -0700, David Decotigny wrote:
> This makes sure the ethtool's set_settings() callback of network
> drivers don't ignore the 16 most significant bits when ethtool calls
> their set_settings().
> 
> All the driver compiled with make allyesconfig on x86_64 have been
> updated.

You missed one generic function, mdio45_ethtool_gset_npage() in
drivers/net/mdio.c.

[...]
> diff --git a/drivers/net/dl2k.c b/drivers/net/dl2k.c
> index c05db60..ba6c151 100644
> --- a/drivers/net/dl2k.c
> +++ b/drivers/net/dl2k.c
> @@ -1219,11 +1219,11 @@ static int rio_set_settings(struct net_device *dev, struct ethtool_cmd *cmd)
>  	} else {
>  		np->an_enable = 0;
>  		if (np->speed == 1000) {
> -			cmd->speed = SPEED_100;
> +			ethtool_cmd_speed_set(cmd, SPEED_100);
>  			cmd->duplex = DUPLEX_FULL;
>  			printk("Warning!! Can't disable Auto negotiation in 1000Mbps, change to Manual 100Mbps, Full duplex.\n");
>  		}
> -		switch(cmd->speed + cmd->duplex) {
> +		switch (ethtool_cmd_speed(cmd) + cmd->duplex) {
[...]

If you're going to stop these drivers ignoring speed_hi, maybe you
should also stop them ignoring the difference between speed and duplex!
Currently the user can ask for 99 Mbit/s full-duplex and get 100 Mbit/s
half-duplex.

There are several others that use this trick.

Ben.

-- 
Ben Hutchings, Senior Software Engineer, Solarflare
Not speaking for my employer; that's the marketing department's job.
They asked us to note that Solarflare product names are trademarked.