[U-Boot] [PATCH] ARMv7: Add missing boards to MAKEALL

[Reinhard Meyer <u-boot@emk-elektronik.de>]

Dear Albert,
> > After Reinhard's remark on boards.cfg vs MAKEALL, I may have accepted
> > the patch a bit hastily. All of these boards are already in boards.cfg,
> > and need not be in makeall IIUC.
> >
> > Thus, I am rolling back master one notch and will mark the patch as
> > Supersedes (could not find a better match for "not needed any more")
> 
> ... or not: here, adding this patch should have resulted in 12 more 
> boards built and 12 more boards failing to build, but actuelly 9 succeed.
> 
> Reinhard, are you sure that boards that are in boards.cfg *and* in 
> MAKEALL will fail to build? This is not consistent with what I see here 
> with this patch.

When at91sam9261 was still in MAKEALL, it did build clean (no errors or
warnings), but the report at the end of a MAKEALL run had it in the list
of boards with problems. After removing it from MAKEALL the effect was
gone. I also noticed that it was not build twice, as one might expect.

Maybe the effect was only there with an explicit "MAKEALL at91", I don't
know - and its not worth to experiment there :)

On any account, however, boards in boards.cfg are automatically included
in a MAKEALL run.

Best Regards,
Reinhard