[PATCH] mpc8315: build u-boot v2012.04 by default.

[Paul Gortmaker <paul.gortmaker@windriver.com>]

Validated on real hardware:

   U-Boot 2012.04.01 (Jun 29 2012 - 13:48:03)MPC83XX

   Reset Status: Software Hard, External/Internal Soft, External/Internal Hard

   CPU:   e300c3, MPC8315E, Rev: 1.2 at 400 MHz, CSB: 133.333 MHz
   Board: Freescale MPC8315ERDB Rev 1.0
   I2C:   ready
   DRAM:  128 MiB (DDR2, 32-bit, ECC off, 266.667 MHz)
   Flash: 8 MiB
   NAND:  32 MiB
   PCIE0: No link
   PCIE1: No link
   In:    serial
   Out:   serial
   Err:   serial
   Net:   eTSEC0, eTSEC1
   Hit any key to stop autoboot:  0

[YOCTO #943]

Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
---

[Note -- this depends on the series of three patches that I
 just sent to oe-core for u-boot, in order to build properly. ]

 meta-yocto/conf/machine/mpc8315e-rdb.conf |    4 ++++
 1 file changed, 4 insertions(+)

diff --git a/meta-yocto/conf/machine/mpc8315e-rdb.conf b/meta-yocto/conf/machine/mpc8315e-rdb.conf
index 03b5f34..09670e5 100644
--- a/meta-yocto/conf/machine/mpc8315e-rdb.conf
+++ b/meta-yocto/conf/machine/mpc8315e-rdb.conf
@@ -7,6 +7,9 @@ require conf/machine/include/tune-ppc603e.inc
 
 KERNEL_IMAGETYPE = "uImage"
 
+EXTRA_IMAGEDEPENDS += "u-boot"
+UBOOT_MACHINE_mpc8315e-rdb = "MPC8315ERDB_config"
+
 SERIAL_CONSOLE = "115200 ttyS0"
 
 MACHINE_FEATURES = "keyboard pci ext2 ext3 serial"
@@ -17,6 +20,7 @@ PREFERRED_PROVIDER_virtual/kernel = "linux-yocto"
 PREFERRED_PROVIDER_virtual/xserver = "xserver-kdrive"
 XSERVER = "xserver-kdrive-fbdev"
 
+PREFERRED_VERSION_u-boot ?= "v2012.04%"
 UBOOT_ENTRYPOINT = "0x00000000"
 
 KERNEL_DEVICETREE = "${S}/arch/powerpc/boot/dts/mpc8315erdb.dts"
-- 
1.7.9.6