Re: [linux-lvm] read_intr errors

["Karl" <rmvzj001@sneakemail.com>]

Have you tried mke2fs with the -c option in LVM and on the drive without
LVM?  I'm seeing a lot of errors on a SCSI disk that has no hardware
problems unless it is in LVM.

On Wed, Oct 17, 2001 at 02:27:21AM -0700, Erick Calder e@arix.com XXXXXXXXXXXXXXXXXXXX wrote:
> hi everyone, I've read a number of dialogues on the archives concerning the
> errors below which I'm getting but have not found any answers:
> 
> I'm running RedHat 7.0 (2.4.9 kernel + LVM 1.0.1rc1) on a little PIII box
> and I'm using the ide controllers built into the motherboard (drivers built
> into the kernel - not modules).  I have CONFIG_IDEDISK_MULTI_MODE set to y
> in the .config for the kernel.  The drive is an IBM-DTLA-307030 (as reported
> by /proc/ide) and is brand new.
> 
> here are the errors:
> 
> Oct 17 02:00:34 beowulf kernel: hdc: read_intr: error=0x04 {
> DriveStatusError }
> Oct 17 02:00:34 beowulf kernel: hdc: read_intr: status=0x59 { DriveReady
> SeekComplete DataRequest Error }
> Oct 17 02:00:34 beowulf kernel: hdc: read_intr: error=0x04 {
> DriveStatusError }
> Oct 17 02:00:34 beowulf kernel: ide1: reset: success
> 
> I've been moving data in and out of the drive and everything seems ok but I
> get lots of the above errors which leaves me with a queasy feeling...
> anyone know what the deal is with this?
> 
> 1k thx - e
> 
> 
> _______________________________________________
> linux-lvm mailing list
> linux-lvm@sistina.com
> http://lists.sistina.com/mailman/listinfo/linux-lvm
> read the LVM HOW-TO at http://www.sistina.com/lvm/Pages/howto.html

-- 
Karl Hakimian
XXXXXXXXXXXXXXXX