From: Aaron Lu <aaron.lu@intel.com>
To: Alan Stern <stern@rowland.harvard.edu>,
Jens Axboe <axboe@kernel.dk>, "Rafael J. Wysocki" <rjw@sisk.pl>,
James Bottomley <James.Bottomley@hansenpartnership.com>
Cc: linux-pm@vger.kernel.org, linux-scsi@vger.kernel.org,
linux-kernel@vger.kernel.org, linux-ide@vger.kernel.org,
Aaron Lu <aaron.lwe@gmail.com>, Aaron Lu <aaron.lu@intel.com>,
Shane Huang <shane.huang@amd.com>
Subject: [PATCH v9 4/4] sd: change to auto suspend mode
Date: Tue, 5 Feb 2013 16:03:16 +0800 [thread overview]
Message-ID: <1360051396-3080-5-git-send-email-aaron.lu@intel.com> (raw)
In-Reply-To: <1360051396-3080-1-git-send-email-aaron.lu@intel.com>
From: Lin Ming <ming.m.lin@intel.com>
Uses block layer runtime pm helper functions in
scsi_runtime_suspend/resume for devices that take advantage of it.
Remove scsi_autopm_* from sd open/release path and check_events path.
Signed-off-by: Lin Ming <ming.m.lin@intel.com>
Signed-off-by: Aaron Lu <aaron.lu@intel.com>
---
drivers/scsi/scsi_pm.c | 79 +++++++++++++++++++++++++++++++++++++++++---------
drivers/scsi/sd.c | 13 +--------
2 files changed, 67 insertions(+), 25 deletions(-)
diff --git a/drivers/scsi/scsi_pm.c b/drivers/scsi/scsi_pm.c
index 8f6b12c..01c6a2e 100644
--- a/drivers/scsi/scsi_pm.c
+++ b/drivers/scsi/scsi_pm.c
@@ -144,33 +144,78 @@ static int scsi_bus_restore(struct device *dev)
#ifdef CONFIG_PM_RUNTIME
+static int sdev_blk_runtime_suspend(struct scsi_device *sdev,
+ int (*cb)(struct device *))
+{
+ int err;
+
+ err = blk_pre_runtime_suspend(sdev->request_queue);
+ if (err)
+ return err;
+ if (cb)
+ err = cb(&sdev->sdev_gendev);
+ blk_post_runtime_suspend(sdev->request_queue, err);
+
+ return err;
+}
+
+static int sdev_runtime_suspend(struct device *dev)
+{
+ const struct dev_pm_ops *pm = dev->driver ? dev->driver->pm : NULL;
+ int (*cb)(struct device *) = pm ? pm->runtime_suspend : NULL;
+ struct scsi_device *sdev = to_scsi_device(dev);
+
+ if (sdev->request_queue->dev)
+ return sdev_blk_runtime_suspend(sdev, cb);
+ else
+ return scsi_dev_type_suspend(dev, cb);
+}
+
static int scsi_runtime_suspend(struct device *dev)
{
int err = 0;
- const struct dev_pm_ops *pm = dev->driver ? dev->driver->pm : NULL;
dev_dbg(dev, "scsi_runtime_suspend\n");
- if (scsi_is_sdev_device(dev)) {
- err = scsi_dev_type_suspend(dev,
- pm ? pm->runtime_suspend : NULL);
- if (err == -EAGAIN)
- pm_schedule_suspend(dev, jiffies_to_msecs(
- round_jiffies_up_relative(HZ/10)));
- }
+ if (scsi_is_sdev_device(dev))
+ err = sdev_runtime_suspend(dev);
/* Insert hooks here for targets, hosts, and transport classes */
return err;
}
-static int scsi_runtime_resume(struct device *dev)
+static int sdev_blk_runtime_resume(struct scsi_device *sdev,
+ int (*cb)(struct device *))
{
int err = 0;
+
+ blk_pre_runtime_resume(sdev->request_queue);
+ if (cb)
+ err = cb(&sdev->sdev_gendev);
+ blk_post_runtime_resume(sdev->request_queue, err);
+
+ return err;
+}
+
+static int sdev_runtime_resume(struct device *dev)
+{
+ struct scsi_device *sdev = to_scsi_device(dev);
const struct dev_pm_ops *pm = dev->driver ? dev->driver->pm : NULL;
+ int (*cb)(struct device *) = pm ? pm->runtime_resume : NULL;
+
+ if (sdev->request_queue->dev)
+ return sdev_blk_runtime_resume(sdev, cb);
+ else
+ return scsi_dev_type_resume(dev, cb);
+}
+
+static int scsi_runtime_resume(struct device *dev)
+{
+ int err = 0;
dev_dbg(dev, "scsi_runtime_resume\n");
if (scsi_is_sdev_device(dev))
- err = scsi_dev_type_resume(dev, pm ? pm->runtime_resume : NULL);
+ err = sdev_runtime_resume(dev);
/* Insert hooks here for targets, hosts, and transport classes */
@@ -185,10 +230,18 @@ static int scsi_runtime_idle(struct device *dev)
/* Insert hooks here for targets, hosts, and transport classes */
- if (scsi_is_sdev_device(dev))
- err = pm_schedule_suspend(dev, 100);
- else
+ if (scsi_is_sdev_device(dev)) {
+ struct scsi_device *sdev = to_scsi_device(dev);
+
+ if (sdev->request_queue->dev) {
+ pm_runtime_mark_last_busy(dev);
+ err = pm_runtime_autosuspend(dev);
+ } else {
+ err = pm_runtime_suspend(dev);
+ }
+ } else {
err = pm_runtime_suspend(dev);
+ }
return err;
}
diff --git a/drivers/scsi/sd.c b/drivers/scsi/sd.c
index c6e2b34..5000bec 100644
--- a/drivers/scsi/sd.c
+++ b/drivers/scsi/sd.c
@@ -1121,10 +1121,6 @@ static int sd_open(struct block_device *bdev, fmode_t mode)
sdev = sdkp->device;
- retval = scsi_autopm_get_device(sdev);
- if (retval)
- goto error_autopm;
-
/*
* If the device is in error recovery, wait until it is done.
* If the device is offline, then disallow any access to it.
@@ -1169,8 +1165,6 @@ static int sd_open(struct block_device *bdev, fmode_t mode)
return 0;
error_out:
- scsi_autopm_put_device(sdev);
-error_autopm:
scsi_disk_put(sdkp);
return retval;
}
@@ -1205,7 +1199,6 @@ static int sd_release(struct gendisk *disk, fmode_t mode)
* XXX is followed by a "rmmod sd_mod"?
*/
- scsi_autopm_put_device(sdev);
scsi_disk_put(sdkp);
return 0;
}
@@ -1367,14 +1360,9 @@ static unsigned int sd_check_events(struct gendisk *disk, unsigned int clearing)
retval = -ENODEV;
if (scsi_block_when_processing_errors(sdp)) {
- retval = scsi_autopm_get_device(sdp);
- if (retval)
- goto out;
-
sshdr = kzalloc(sizeof(*sshdr), GFP_KERNEL);
retval = scsi_test_unit_ready(sdp, SD_TIMEOUT, SD_MAX_RETRIES,
sshdr);
- scsi_autopm_put_device(sdp);
}
/* failed to execute TUR, assume media not present */
@@ -2839,6 +2827,7 @@ static void sd_probe_async(void *data, async_cookie_t cookie)
sd_printk(KERN_NOTICE, sdkp, "Attached SCSI %sdisk\n",
sdp->removable ? "removable " : "");
+ blk_pm_runtime_init(sdp->request_queue, dev);
scsi_autopm_put_device(sdp);
put_device(&sdkp->dev);
}
--
1.8.1
next prev parent reply other threads:[~2013-02-05 8:03 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-02-05 8:03 [PATCH v9 0/4] block layer runtime pm Aaron Lu
2013-02-05 8:03 ` [PATCH v9 1/4] block: add a flag to identify PM request Aaron Lu
2013-02-05 8:03 ` [PATCH v9 2/4] block: add runtime pm helpers Aaron Lu
2013-02-05 8:03 ` [PATCH v9 3/4] block: implement runtime pm strategy Aaron Lu
2013-02-19 2:29 ` Aaron Lu
2013-02-19 16:34 ` Alan Stern
2013-02-19 16:34 ` Alan Stern
2013-02-05 8:03 ` Aaron Lu [this message]
2013-02-05 16:51 ` [PATCH v9 4/4] sd: change to auto suspend mode Alan Stern
2013-02-05 16:51 ` Alan Stern
2013-02-06 2:10 ` Aaron Lu
2013-02-06 15:51 ` Alan Stern
2013-02-06 15:51 ` Alan Stern
2013-02-18 3:20 ` Aaron Lu
2013-02-18 21:55 ` Alan Stern
2013-02-18 21:55 ` Alan Stern
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1360051396-3080-5-git-send-email-aaron.lu@intel.com \
--to=aaron.lu@intel.com \
--cc=James.Bottomley@hansenpartnership.com \
--cc=aaron.lwe@gmail.com \
--cc=axboe@kernel.dk \
--cc=linux-ide@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=linux-scsi@vger.kernel.org \
--cc=rjw@sisk.pl \
--cc=shane.huang@amd.com \
--cc=stern@rowland.harvard.edu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.