[PATCH 13/13] mmc: sdhci: Change to new way of doing re-tuning

[Adrian Hunter <adrian.hunter@intel.com>]

Make use of mmc core support for re-tuning instead
of doing it all in the sdhci driver.

This patch also changes to flag the need for re-tuning
always after runtime suspend when tuning has been used
at initialization. Previously it was only done if
the re-tuning timer was in use.

Signed-off-by: Adrian Hunter <adrian.hunter@intel.com>
---
 drivers/mmc/host/sdhci.c  | 113 ++++++----------------------------------------
 include/linux/mmc/sdhci.h |   3 --
 2 files changed, 14 insertions(+), 102 deletions(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index dd4cc4c..4e50db1 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -51,7 +51,6 @@ static void sdhci_finish_data(struct sdhci_host *);
 
 static void sdhci_finish_command(struct sdhci_host *);
 static int sdhci_execute_tuning(struct mmc_host *mmc, u32 opcode);
-static void sdhci_tuning_timer(unsigned long data);
 static void sdhci_enable_preset_value(struct sdhci_host *host, bool enable);
 
 #ifdef CONFIG_PM_RUNTIME
@@ -249,17 +248,6 @@ static void sdhci_init(struct sdhci_host *host, int soft)
 static void sdhci_reinit(struct sdhci_host *host)
 {
 	sdhci_init(host, 0);
-	/*
-	 * Retuning stuffs are affected by different cards inserted and only
-	 * applicable to UHS-I cards. So reset these fields to their initial
-	 * value when card is removed.
-	 */
-	if (host->flags & SDHCI_USING_RETUNING_TIMER) {
-		host->flags &= ~SDHCI_USING_RETUNING_TIMER;
-
-		del_timer_sync(&host->tuning_timer);
-		host->flags &= ~SDHCI_NEEDS_RETUNING;
-	}
 	sdhci_enable_card_detection(host);
 }
 
@@ -1345,7 +1333,6 @@ static void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
 	struct sdhci_host *host;
 	int present;
 	unsigned long flags;
-	u32 tuning_opcode;
 
 	host = mmc_priv(mmc);
 
@@ -1393,39 +1380,6 @@ static void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
 		host->mrq->cmd->error = -ENOMEDIUM;
 		tasklet_schedule(&host->finish_tasklet);
 	} else {
-		u32 present_state;
-
-		present_state = sdhci_readl(host, SDHCI_PRESENT_STATE);
-		/*
-		 * Check if the re-tuning timer has already expired and there
-		 * is no on-going data transfer and DAT0 is not busy. If so,
-		 * we need to execute tuning procedure before sending command.
-		 */
-		if ((host->flags & SDHCI_NEEDS_RETUNING) &&
-		    !(present_state & (SDHCI_DOING_WRITE | SDHCI_DOING_READ)) &&
-		    (present_state & SDHCI_DATA_0_LVL_MASK)) {
-			if (mmc->card) {
-				/* eMMC uses cmd21 but sd and sdio use cmd19 */
-				tuning_opcode =
-					mmc->card->type == MMC_TYPE_MMC ?
-					MMC_SEND_TUNING_BLOCK_HS200 :
-					MMC_SEND_TUNING_BLOCK;
-
-				/* Here we need to set the host->mrq to NULL,
-				 * in case the pending finish_tasklet
-				 * finishes it incorrectly.
-				 */
-				host->mrq = NULL;
-
-				spin_unlock_irqrestore(&host->lock, flags);
-				sdhci_execute_tuning(mmc, tuning_opcode);
-				spin_lock_irqsave(&host->lock, flags);
-
-				/* Restore original mmc_request structure */
-				host->mrq = mrq;
-			}
-		}
-
 		if (mrq->sbc && !(host->flags & SDHCI_AUTO_CMD23))
 			sdhci_send_command(host, mrq->sbc);
 		else
@@ -2065,23 +2019,19 @@ static int sdhci_execute_tuning(struct mmc_host *mmc, u32 opcode)
 	}
 
 out:
-	host->flags &= ~SDHCI_NEEDS_RETUNING;
-
 	if (tuning_count) {
-		host->flags |= SDHCI_USING_RETUNING_TIMER;
-		mod_timer(&host->tuning_timer, jiffies + tuning_count * HZ);
+		/*
+		 * In case tuning fails, host controllers which support
+		 * re-tuning can try tuning again at a later time, when the
+		 * re-tuning timer expires.  So for these controllers, we
+		 * return 0. Since there might be other controllers who do not
+		 * have this capability, we return error for them.
+		 */
+		err = 0;
 	}
 
-	/*
-	 * In case tuning fails, host controllers which support re-tuning can
-	 * try tuning again at a later time, when the re-tuning timer expires.
-	 * So for these controllers, we return 0. Since there might be other
-	 * controllers who do not have this capability, we return error for
-	 * them. SDHCI_USING_RETUNING_TIMER means the host is currently using
-	 * a retuning timer to do the retuning for the card.
-	 */
-	if (err && (host->flags & SDHCI_USING_RETUNING_TIMER))
-		err = 0;
+	if (!err)
+		mmc_retune_enable(host->mmc, tuning_count);
 
 	sdhci_writel(host, host->ier, SDHCI_INT_ENABLE);
 	sdhci_writel(host, host->ier, SDHCI_SIGNAL_ENABLE);
@@ -2261,20 +2211,6 @@ static void sdhci_timeout_timer(unsigned long data)
 	spin_unlock_irqrestore(&host->lock, flags);
 }
 
-static void sdhci_tuning_timer(unsigned long data)
-{
-	struct sdhci_host *host;
-	unsigned long flags;
-
-	host = (struct sdhci_host *)data;
-
-	spin_lock_irqsave(&host->lock, flags);
-
-	host->flags |= SDHCI_NEEDS_RETUNING;
-
-	spin_unlock_irqrestore(&host->lock, flags);
-}
-
 /*****************************************************************************\
  *                                                                           *
  * Interrupt handling                                                        *
@@ -2652,11 +2588,8 @@ int sdhci_suspend_host(struct sdhci_host *host)
 {
 	sdhci_disable_card_detection(host);
 
-	/* Disable tuning since we are suspending */
-	if (host->flags & SDHCI_USING_RETUNING_TIMER) {
-		del_timer_sync(&host->tuning_timer);
-		host->flags &= ~SDHCI_NEEDS_RETUNING;
-	}
+	mmc_retune_timer_stop(host->mmc);
+	mmc_retune_needed(host->mmc);
 
 	if (!device_may_wakeup(mmc_dev(host->mmc))) {
 		host->ier = 0;
@@ -2706,10 +2639,6 @@ int sdhci_resume_host(struct sdhci_host *host)
 
 	sdhci_enable_card_detection(host);
 
-	/* Set the re-tuning expiration flag */
-	if (host->flags & SDHCI_USING_RETUNING_TIMER)
-		host->flags |= SDHCI_NEEDS_RETUNING;
-
 	return ret;
 }
 
@@ -2749,11 +2678,8 @@ int sdhci_runtime_suspend_host(struct sdhci_host *host)
 {
 	unsigned long flags;
 
-	/* Disable tuning since we are suspending */
-	if (host->flags & SDHCI_USING_RETUNING_TIMER) {
-		del_timer_sync(&host->tuning_timer);
-		host->flags &= ~SDHCI_NEEDS_RETUNING;
-	}
+	mmc_retune_timer_stop(host->mmc);
+	mmc_retune_needed(host->mmc);
 
 	spin_lock_irqsave(&host->lock, flags);
 	host->ier &= SDHCI_INT_CARD_INT;
@@ -2796,10 +2722,6 @@ int sdhci_runtime_resume_host(struct sdhci_host *host)
 		spin_unlock_irqrestore(&host->lock, flags);
 	}
 
-	/* Set the re-tuning expiration flag */
-	if (host->flags & SDHCI_USING_RETUNING_TIMER)
-		host->flags |= SDHCI_NEEDS_RETUNING;
-
 	spin_lock_irqsave(&host->lock, flags);
 
 	host->runtime_suspended = false;
@@ -3333,13 +3255,6 @@ int sdhci_add_host(struct sdhci_host *host)
 
 	init_waitqueue_head(&host->buf_ready_int);
 
-	if (host->version >= SDHCI_SPEC_300) {
-		/* Initialize re-tuning timer */
-		init_timer(&host->tuning_timer);
-		host->tuning_timer.data = (unsigned long)host;
-		host->tuning_timer.function = sdhci_tuning_timer;
-	}
-
 	sdhci_init(host, 0);
 
 	ret = request_threaded_irq(host->irq, sdhci_irq, sdhci_thread_irq,
diff --git a/include/linux/mmc/sdhci.h b/include/linux/mmc/sdhci.h
index f767a0d..c59ef8d 100644
--- a/include/linux/mmc/sdhci.h
+++ b/include/linux/mmc/sdhci.h
@@ -129,13 +129,11 @@ struct sdhci_host {
 #define SDHCI_REQ_USE_DMA	(1<<2)	/* Use DMA for this req. */
 #define SDHCI_DEVICE_DEAD	(1<<3)	/* Device unresponsive */
 #define SDHCI_SDR50_NEEDS_TUNING (1<<4)	/* SDR50 needs tuning */
-#define SDHCI_NEEDS_RETUNING	(1<<5)	/* Host needs retuning */
 #define SDHCI_AUTO_CMD12	(1<<6)	/* Auto CMD12 support */
 #define SDHCI_AUTO_CMD23	(1<<7)	/* Auto CMD23 support */
 #define SDHCI_PV_ENABLED	(1<<8)	/* Preset value enabled */
 #define SDHCI_SDIO_IRQ_ENABLED	(1<<9)	/* SDIO irq enabled */
 #define SDHCI_SDR104_NEEDS_TUNING (1<<10)	/* SDR104/HS200 needs tuning */
-#define SDHCI_USING_RETUNING_TIMER (1<<11)	/* Host is using a retuning timer for the card */
 #define SDHCI_USE_64_BIT_DMA	(1<<12)	/* Use 64-bit DMA */
 #define SDHCI_HS400_TUNING	(1<<13)	/* Tuning for HS400 */
 
@@ -201,7 +199,6 @@ struct sdhci_host {
 	unsigned int		tuning_count;	/* Timer count for re-tuning */
 	unsigned int		tuning_mode;	/* Re-tuning mode supported by host */
 #define SDHCI_TUNING_MODE_1	0
-	struct timer_list	tuning_timer;	/* Timer for tuning */
 
 	unsigned long private[0] ____cacheline_aligned;
 };
-- 
1.9.1