From: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
To: cw00.choi@samsung.com, lee.jones@linaro.org
Cc: myungjoo.ham@samsung.com, sameo@linux.intel.com,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
patches@opensource.wolfsonmicro.com
Subject: [PATCH RESEND 5/5] mfd: arizona: Update DT doc for new mic detection bindings
Date: Wed, 9 Sep 2015 09:34:50 +0100 [thread overview]
Message-ID: <1441787690-30148-5-git-send-email-ckeepax@opensource.wolfsonmicro.com> (raw)
In-Reply-To: <1441787690-30148-1-git-send-email-ckeepax@opensource.wolfsonmicro.com>
Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
---
Documentation/devicetree/bindings/mfd/arizona.txt | 21 +++++++++++++++++++++
include/dt-bindings/mfd/arizona.h | 5 +++++
2 files changed, 26 insertions(+), 0 deletions(-)
diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
index a8fee60..b98a11b 100644
--- a/Documentation/devicetree/bindings/mfd/arizona.txt
+++ b/Documentation/devicetree/bindings/mfd/arizona.txt
@@ -73,6 +73,27 @@ Optional properties:
If this node is not mentioned or if the value is unknown, then
headphone detection mode is set to HPDETL.
+ - wlf,micd-software-compare : Use a software comparison to determine mic
+ presence
+ - wlf,micd-detect-debounce : Additional software microphone detection
+ debounce specified in milliseconds.
+ - wlf,micd-pol-gpio : GPIO specifier for the GPIO controlling the headset
+ polarity if one exists.
+ - wlf,micd-bias-start-time : Time allowed for MICBIAS to startup prior to
+ performing microphone detection, specified as per the ARIZONA_MICD_TIME_XXX
+ defines.
+ - wlf,micd-rate : Delay between successive microphone detection measurements,
+ specified as per the ARIZONA_MICD_TIME_XXX defines.
+ - wlf,micd-dbtime : Microphone detection hardware debounces specified as the
+ number of measurements to take, valid values being 2 and 4.
+ - wlf,micd-timeout : Timeout for microphone detection, specified in
+ milliseconds.
+ - wlf,micd-force-micbias : Force MICBIAS continuously on during microphone
+ detection.
+
+ - wlf,gpsw : Settings for the general purpose switch, set as one of the
+ ARIZONA_GPSW_XXX defines.
+
- DCVDD-supply, MICVDD-supply : Power supplies, only need to be specified if
they are being externally supplied. As covered in
Documentation/devicetree/bindings/regulator/regulator.txt
diff --git a/include/dt-bindings/mfd/arizona.h b/include/dt-bindings/mfd/arizona.h
index c40f665..dedf46f 100644
--- a/include/dt-bindings/mfd/arizona.h
+++ b/include/dt-bindings/mfd/arizona.h
@@ -110,4 +110,9 @@
#define ARIZONA_ACCDET_MODE_HPM 4
#define ARIZONA_ACCDET_MODE_ADC 7
+#define ARIZONA_GPSW_OPEN 0
+#define ARIZONA_GPSW_CLOSED 1
+#define ARIZONA_GPSW_CLAMP_ENABLED 2
+#define ARIZONA_GPSW_CLAMP_DISABLED 3
+
#endif
--
1.7.2.5
WARNING: multiple messages have this Message-ID (diff)
From: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
To: <cw00.choi@samsung.com>, <lee.jones@linaro.org>
Cc: <myungjoo.ham@samsung.com>, <sameo@linux.intel.com>,
<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
<patches@opensource.wolfsonmicro.com>
Subject: [PATCH RESEND 5/5] mfd: arizona: Update DT doc for new mic detection bindings
Date: Wed, 9 Sep 2015 09:34:50 +0100 [thread overview]
Message-ID: <1441787690-30148-5-git-send-email-ckeepax@opensource.wolfsonmicro.com> (raw)
In-Reply-To: <1441787690-30148-1-git-send-email-ckeepax@opensource.wolfsonmicro.com>
Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
---
Documentation/devicetree/bindings/mfd/arizona.txt | 21 +++++++++++++++++++++
include/dt-bindings/mfd/arizona.h | 5 +++++
2 files changed, 26 insertions(+), 0 deletions(-)
diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
index a8fee60..b98a11b 100644
--- a/Documentation/devicetree/bindings/mfd/arizona.txt
+++ b/Documentation/devicetree/bindings/mfd/arizona.txt
@@ -73,6 +73,27 @@ Optional properties:
If this node is not mentioned or if the value is unknown, then
headphone detection mode is set to HPDETL.
+ - wlf,micd-software-compare : Use a software comparison to determine mic
+ presence
+ - wlf,micd-detect-debounce : Additional software microphone detection
+ debounce specified in milliseconds.
+ - wlf,micd-pol-gpio : GPIO specifier for the GPIO controlling the headset
+ polarity if one exists.
+ - wlf,micd-bias-start-time : Time allowed for MICBIAS to startup prior to
+ performing microphone detection, specified as per the ARIZONA_MICD_TIME_XXX
+ defines.
+ - wlf,micd-rate : Delay between successive microphone detection measurements,
+ specified as per the ARIZONA_MICD_TIME_XXX defines.
+ - wlf,micd-dbtime : Microphone detection hardware debounces specified as the
+ number of measurements to take, valid values being 2 and 4.
+ - wlf,micd-timeout : Timeout for microphone detection, specified in
+ milliseconds.
+ - wlf,micd-force-micbias : Force MICBIAS continuously on during microphone
+ detection.
+
+ - wlf,gpsw : Settings for the general purpose switch, set as one of the
+ ARIZONA_GPSW_XXX defines.
+
- DCVDD-supply, MICVDD-supply : Power supplies, only need to be specified if
they are being externally supplied. As covered in
Documentation/devicetree/bindings/regulator/regulator.txt
diff --git a/include/dt-bindings/mfd/arizona.h b/include/dt-bindings/mfd/arizona.h
index c40f665..dedf46f 100644
--- a/include/dt-bindings/mfd/arizona.h
+++ b/include/dt-bindings/mfd/arizona.h
@@ -110,4 +110,9 @@
#define ARIZONA_ACCDET_MODE_HPM 4
#define ARIZONA_ACCDET_MODE_ADC 7
+#define ARIZONA_GPSW_OPEN 0
+#define ARIZONA_GPSW_CLOSED 1
+#define ARIZONA_GPSW_CLAMP_ENABLED 2
+#define ARIZONA_GPSW_CLAMP_DISABLED 3
+
#endif
--
1.7.2.5
next prev parent reply other threads:[~2015-09-09 8:34 UTC|newest]
Thread overview: 22+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-09-09 8:34 [PATCH RESEND 1/5] mfd: arizona: Add registers for ADC microphone detection Charles Keepax
2015-09-09 8:34 ` Charles Keepax
2015-09-09 8:34 ` [PATCH RESEND 2/5] extcon: arizona: Add support for new ADC value headphone detect Charles Keepax
2015-09-09 8:34 ` Charles Keepax
[not found] ` <1441787690-30148-2-git-send-email-ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
2015-09-11 7:49 ` Chanwoo Choi
2015-09-11 7:49 ` Chanwoo Choi
2015-09-09 8:34 ` [PATCH RESEND 3/5] mfd: arizona: Add register bits for general purpose switch Charles Keepax
2015-09-09 8:34 ` Charles Keepax
2015-09-09 8:34 ` [PATCH RESEND 4/5] extcon: arizona: Add support " Charles Keepax
2015-09-09 8:34 ` Charles Keepax
2015-09-11 7:50 ` Chanwoo Choi
2015-09-09 8:34 ` Charles Keepax [this message]
2015-09-09 8:34 ` [PATCH RESEND 5/5] mfd: arizona: Update DT doc for new mic detection bindings Charles Keepax
2015-09-11 7:52 ` Chanwoo Choi
[not found] ` <55F2884A.5000707-Sze3O3UU22JBDgjK7y7TUQ@public.gmane.org>
2015-09-15 4:10 ` Chanwoo Choi
2015-09-15 4:10 ` Chanwoo Choi
[not found] ` <1441787690-30148-1-git-send-email-ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
2015-09-11 7:57 ` [PATCH RESEND 1/5] mfd: arizona: Add registers for ADC microphone detection Chanwoo Choi
2015-09-11 7:57 ` Chanwoo Choi
2015-09-11 8:58 ` Lee Jones
-- strict thread matches above, loose matches on Subject: below --
2015-08-11 8:14 Charles Keepax
[not found] ` <1439280844-9808-1-git-send-email-ckeepax-yzvPICuk2AATkU/dhu1WVueM+bqZidxxQQ4Iyu8u01E@public.gmane.org>
2015-08-11 8:14 ` [PATCH RESEND 5/5] mfd: arizona: Update DT doc for new mic detection bindings Charles Keepax
2015-08-11 8:14 ` Charles Keepax
2015-08-12 8:22 ` Lee Jones
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1441787690-30148-5-git-send-email-ckeepax@opensource.wolfsonmicro.com \
--to=ckeepax@opensource.wolfsonmicro.com \
--cc=cw00.choi@samsung.com \
--cc=devicetree@vger.kernel.org \
--cc=lee.jones@linaro.org \
--cc=linux-kernel@vger.kernel.org \
--cc=myungjoo.ham@samsung.com \
--cc=patches@opensource.wolfsonmicro.com \
--cc=sameo@linux.intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.