[PATCH 6/6 RESEND] mfd: arizona: use correct type ID for device tree config

[Richard Fitzgerald <rf@opensource.wolfsonmicro.com>]

In the case of a device tree config the code uses the device ID
from the DT entry to check which codec is required but when storing
the ID into struct arizona it was always using the non-DT SPI device
table to get an ID.

This patch changes the code to store the correct ID into struct arizona.

Signed-off-by: Richard Fitzgerald <rf@opensource.wolfsonmicro.com>
---
 drivers/mfd/arizona-i2c.c | 5 ++---
 drivers/mfd/arizona-spi.c | 5 ++---
 2 files changed, 4 insertions(+), 6 deletions(-)

diff --git a/drivers/mfd/arizona-i2c.c b/drivers/mfd/arizona-i2c.c
index 914bdce..4e3afd1 100644
--- a/drivers/mfd/arizona-i2c.c
+++ b/drivers/mfd/arizona-i2c.c
@@ -56,8 +56,7 @@ static int arizona_i2c_probe(struct i2c_client *i2c,
 			regmap_config = &wm8998_i2c_regmap;
 		break;
 	default:
-		dev_err(&i2c->dev, "Unknown device type %ld\n",
-			id->driver_data);
+		dev_err(&i2c->dev, "Unknown device type %ld\n", type);
 		return -EINVAL;
 	}
 
@@ -79,7 +78,7 @@ static int arizona_i2c_probe(struct i2c_client *i2c,
 		return ret;
 	}
 
-	arizona->type = id->driver_data;
+	arizona->type = type;
 	arizona->dev = &i2c->dev;
 	arizona->irq = i2c->irq;
 
diff --git a/drivers/mfd/arizona-spi.c b/drivers/mfd/arizona-spi.c
index 850a63a..8cffb1c 100644
--- a/drivers/mfd/arizona-spi.c
+++ b/drivers/mfd/arizona-spi.c
@@ -47,8 +47,7 @@ static int arizona_spi_probe(struct spi_device *spi)
 			regmap_config = &wm5110_spi_regmap;
 		break;
 	default:
-		dev_err(&spi->dev, "Unknown device type %ld\n",
-			id->driver_data);
+		dev_err(&spi->dev, "Unknown device type %ld\n", type);
 		return -EINVAL;
 	}
 
@@ -70,7 +69,7 @@ static int arizona_spi_probe(struct spi_device *spi)
 		return ret;
 	}
 
-	arizona->type = id->driver_data;
+	arizona->type = type;
 	arizona->dev = &spi->dev;
 	arizona->irq = spi->irq;
 
-- 
1.9.1