From: Nicolas Saenz Julienne <nicolassaenzj@gmail.com>
To: linus.walleij@linaro.org
Cc: gnurou@gmail.com, linux-gpio@vger.kernel.org,
linux-kernel@vger.kernel.org
Subject: [PATCH] gpio: add tps65218 gpio driver
Date: Sun, 11 Oct 2015 17:41:03 +0100 [thread overview]
Message-ID: <1444581663-31066-1-git-send-email-nicolassaenzj@gmail.com> (raw)
Driver for the GPIO block found in ti's tps65218 pmics.
The device has two GPIOs and one GPO pin which can be configured as follows:
GPIO1:
-general-purpose, open-drain output controlled by GPO1 user bit and/or
sequencer
-DDR3 reset input signal from SOC. Signal is either latched or
passed-trough to GPO2 pin. See below for details.
GPO2:
-general-purpose output controlled by GPO2 user bit
-DDR3 reset output signal. Signal is controlled by GPIO1 and PGOOD.
See below for details.
-Output buffer can be configured as open-drain or push-pull.
GPIO3:
-general-purpose, open-drain output controlled by GPO3 user bit and/or
sequencer
-reset input-signal for DCDC1 and DCDC2.
The input configurations are not meant to be used by the user so the driver
only offers GPOs. Also GPO2 is set-up as open drain by default.
Signed-off-by: Nicolas Saenz Julienne <nicolassaenzj@gmail.com>
---
drivers/gpio/Kconfig | 7 ++
drivers/gpio/Makefile | 1 +
drivers/gpio/gpio-tps65218.c | 165 +++++++++++++++++++++++++++++++++++++++++++
3 files changed, 173 insertions(+)
create mode 100644 drivers/gpio/gpio-tps65218.c
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index 63000b1..1669898 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -822,6 +822,13 @@ config GPIO_TIMBERDALE
---help---
Add support for the GPIO IP in the timberdale FPGA.
+config GPIO_TPS65218
+ tristate "TPS65218 GPIO"
+ depends on MFD_TPS65218
+ help
+ Select this option to enable GPIO driver for the TPS65218
+ chip family.
+
config GPIO_TPS6586X
bool "TPS6586X GPIO"
depends on MFD_TPS6586X
diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
index 77a07e9..d4bd2f9 100644
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -93,6 +93,7 @@ obj-$(CONFIG_GPIO_TC3589X) += gpio-tc3589x.o
obj-$(CONFIG_ARCH_TEGRA) += gpio-tegra.o
obj-$(CONFIG_GPIO_TIMBERDALE) += gpio-timberdale.o
obj-$(CONFIG_GPIO_PALMAS) += gpio-palmas.o
+obj-$(CONFIG_GPIO_TPS65218) += gpio-tps65218.o
obj-$(CONFIG_GPIO_TPS6586X) += gpio-tps6586x.o
obj-$(CONFIG_GPIO_TPS65910) += gpio-tps65910.o
obj-$(CONFIG_GPIO_TPS65912) += gpio-tps65912.o
diff --git a/drivers/gpio/gpio-tps65218.c b/drivers/gpio/gpio-tps65218.c
new file mode 100644
index 0000000..a0b3d52
--- /dev/null
+++ b/drivers/gpio/gpio-tps65218.c
@@ -0,0 +1,165 @@
+/*
+ * Copyright 2015 Verifone Int.
+ *
+ * Author: Nicolas Saenz Julienne <nicolassaenzj@gmail.com>
+ *
+ * This program is free software; you can redistribute it and/or modify i t
+ * under the terms of the GNU General Public License as published by th e
+ * Free Software Foundation; either version 2 of the License, or (at you r
+ * option) any later version.
+ *
+ * This driver is based on the gpio-tps65912 implementation.
+ */
+
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/errno.h>
+#include <linux/gpio.h>
+#include <linux/platform_device.h>
+#include <linux/mfd/tps65218.h>
+
+struct tps65218_gpio {
+ struct tps65218 *tps65218;
+ struct gpio_chip gpio_chip;
+};
+
+#define to_tg(gc) container_of(gc, struct tps65218_gpio, gpio_chip)
+
+static int tps65218_gpio_get(struct gpio_chip *gc, unsigned offset)
+{
+ struct tps65218_gpio *tps65218_gpio = to_tg(gc);
+ struct tps65218 *tps65218 = tps65218_gpio->tps65218;
+ unsigned int val;
+ int ret;
+
+ ret = tps65218_reg_read(tps65218, TPS65218_REG_ENABLE2, &val);
+ if (ret)
+ return ret;
+
+ return val & (TPS65218_ENABLE2_GPIO1 << offset);
+}
+
+static void tps65218_gpio_set(struct gpio_chip *gc, unsigned offset,
+ int value)
+{
+ struct tps65218_gpio *tps65218_gpio = to_tg(gc);
+ struct tps65218 *tps65218 = tps65218_gpio->tps65218;
+
+ if (value)
+ tps65218_set_bits(tps65218, TPS65218_REG_ENABLE2,
+ TPS65218_ENABLE2_GPIO1 << offset,
+ TPS65218_ENABLE2_GPIO1 << offset,
+ TPS65218_PROTECT_L1);
+ else
+ tps65218_clear_bits(tps65218, TPS65218_REG_ENABLE2,
+ TPS65218_ENABLE2_GPIO1 << offset,
+ TPS65218_PROTECT_L1);
+}
+
+static int tps65218_gpio_output(struct gpio_chip *gc, unsigned offset,
+ int value)
+{
+ /* Only drives GPOs */
+ return 0;
+}
+
+static struct gpio_chip template_chip = {
+ .label = "gpio-tps65218",
+ .owner = THIS_MODULE,
+ .direction_output = tps65218_gpio_output,
+ .get = tps65218_gpio_get,
+ .set = tps65218_gpio_set,
+ .can_sleep = true,
+ .ngpio = 3,
+ .base = -1,
+};
+
+static int tps65218_setup_gpos(struct tps65218_gpio *tps65218_gpio)
+{
+ struct tps65218 *tps65218 = tps65218_gpio->tps65218;
+ int ret;
+
+ /* Disable sequencer for GPO1 and GP03 */
+ ret = tps65218_clear_bits(tps65218, TPS65218_REG_SEQ7, 0xFF,
+ TPS65218_PROTECT_L1);
+ if (ret)
+ return ret;
+
+ /* Setup GPO1 and GPO2 */
+ ret = tps65218_clear_bits(tps65218, TPS65218_REG_CONFIG1,
+ TPS65218_CONFIG1_IO1_SEL |
+ TPS65218_CONFIG1_GPO2_BUF,
+ TPS65218_PROTECT_L1);
+ if (ret)
+ return ret;
+
+ /* Setup GPO3 */
+ return tps65218_clear_bits(tps65218, TPS65218_REG_CONFIG2,
+ TPS65218_CONFIG2_DC12_RST,
+ TPS65218_PROTECT_L1);
+}
+
+static int tps65218_gpio_probe(struct platform_device *pdev)
+{
+ struct tps65218 *tps65218 = dev_get_drvdata(pdev->dev.parent);
+ struct tps65218_gpio *tps65218_gpio;
+ int ret;
+
+ tps65218_gpio = devm_kzalloc(&pdev->dev, sizeof(*tps65218_gpio),
+ GFP_KERNEL);
+ if (!tps65218_gpio)
+ return -ENOMEM;
+
+ tps65218_gpio->tps65218 = tps65218;
+ tps65218_gpio->gpio_chip = template_chip;
+ tps65218_gpio->gpio_chip.dev = &pdev->dev;
+ tps65218_gpio->gpio_chip.of_node = pdev->dev.of_node;
+
+ ret = tps65218_setup_gpos(tps65218_gpio);
+ if (ret) {
+ dev_err(&pdev->dev, "Failed to setup gpos, %d\n", ret);
+ return ret;
+ }
+
+ ret = gpiochip_add(&tps65218_gpio->gpio_chip);
+ if (ret < 0) {
+ dev_err(&pdev->dev, "Failed to register gpiochip, %d\n", ret);
+ return ret;
+ }
+
+ platform_set_drvdata(pdev, tps65218_gpio);
+
+ return ret;
+}
+
+static int tps65218_gpio_remove(struct platform_device *pdev)
+{
+ struct tps65218_gpio *tps65218_gpio = platform_get_drvdata(pdev);
+
+ gpiochip_remove(&tps65218_gpio->gpio_chip);
+
+ return 0;
+}
+
+static const struct of_device_id tps65218_dt_match[] = {
+ { .compatible = "ti,tps65218-gpio" },
+ { }
+};
+MODULE_DEVICE_TABLE(of, tps65218_dt_match);
+
+static struct platform_driver tps65218_gpio_driver = {
+ .driver = {
+ .name = "tps65218-gpio",
+ .owner = THIS_MODULE,
+ .of_match_table = of_match_ptr(tps65218_dt_match)
+ },
+ .probe = tps65218_gpio_probe,
+ .remove = tps65218_gpio_remove,
+};
+
+module_platform_driver(tps65218_gpio_driver);
+
+MODULE_ALIAS("platform:tps65218-gpio");
+MODULE_AUTHOR("Nicolas Saenz Julienne <nicolassaenzj@gmail.com>");
+MODULE_DESCRIPTION("GPO interface for TPS65218 PMICs");
+MODULE_LICENSE("GPL v2");
--
2.5.0
next reply other threads:[~2015-10-11 16:41 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-10-11 16:41 Nicolas Saenz Julienne [this message]
2015-10-11 17:12 ` [PATCH] gpio: add tps65218 gpio driver kbuild test robot
2015-10-11 17:12 ` [PATCH] gpio: fix platform_no_drv_owner.cocci warnings kbuild test robot
2015-10-16 20:26 ` [PATCH] gpio: add tps65218 gpio driver Linus Walleij
-- strict thread matches above, loose matches on Subject: below --
2015-10-23 16:33 Nicolas Saenz Julienne
2015-10-24 16:54 ` kbuild test robot
2015-10-29 13:11 ` Linus Walleij
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1444581663-31066-1-git-send-email-nicolassaenzj@gmail.com \
--to=nicolassaenzj@gmail.com \
--cc=gnurou@gmail.com \
--cc=linus.walleij@linaro.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.