All of lore.kernel.org
 help / color / mirror / Atom feed
From: Ondrej Zary <linux@rainbow-software.org>
To: netdev@vger.kernel.org
Cc: Francois Romieu <romieu@fr.zoreil.com>,
	David Miller <davem@davemloft.net>,
	Kernel development list <linux-kernel@vger.kernel.org>
Subject: [PATCH 2/3] dl2k: Reorder and cleanup initialization
Date: Tue, 17 Nov 2015 18:28:17 +0100	[thread overview]
Message-ID: <1447781298-19785-2-git-send-email-linux@rainbow-software.org> (raw)
In-Reply-To: <1447781298-19785-1-git-send-email-linux@rainbow-software.org>

Move HW init and stop into separate functions.
Request IRQ only after the HW has been reset (so interrupts are
disabled and no stale interrupts are pending).

Signed-off-by: Ondrej Zary <linux@rainbow-software.org>
---
 drivers/net/ethernet/dlink/dl2k.c |   95 ++++++++++++++++++++++---------------
 1 file changed, 56 insertions(+), 39 deletions(-)

diff --git a/drivers/net/ethernet/dlink/dl2k.c b/drivers/net/ethernet/dlink/dl2k.c
index ec0eb7f..9e9baa0 100644
--- a/drivers/net/ethernet/dlink/dl2k.c
+++ b/drivers/net/ethernet/dlink/dl2k.c
@@ -252,19 +252,6 @@ rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent)
 	if (err)
 		goto err_out_unmap_rx;
 
-	if (np->chip_id == CHIP_IP1000A &&
-	    (np->pdev->revision == 0x40 || np->pdev->revision == 0x41)) {
-		/* PHY magic taken from ipg driver, undocumented registers */
-		mii_write(dev, np->phy_addr, 31, 0x0001);
-		mii_write(dev, np->phy_addr, 27, 0x01e0);
-		mii_write(dev, np->phy_addr, 31, 0x0002);
-		mii_write(dev, np->phy_addr, 27, 0xeb8e);
-		mii_write(dev, np->phy_addr, 31, 0x0000);
-		mii_write(dev, np->phy_addr, 30, 0x005e);
-		/* advertise 1000BASE-T half & full duplex, prefer MASTER */
-		mii_write(dev, np->phy_addr, MII_CTRL1000, 0x0700);
-	}
-
 	/* Fiber device? */
 	np->phy_media = (dr16(ASICCtrl) & PhyMedia) ? 1 : 0;
 	np->link_status = 0;
@@ -274,13 +261,11 @@ rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent)
 	 	if (np->an_enable == 2) {
 			np->an_enable = 1;
 		}
-		mii_set_media_pcs (dev);
 	} else {
 		/* Auto-Negotiation is mandatory for 1000BASE-T,
 		   IEEE 802.3ab Annex 28D page 14 */
 		if (np->speed == 1000)
 			np->an_enable = 1;
-		mii_set_media (dev);
 	}
 
 	err = register_netdev (dev);
@@ -531,25 +516,13 @@ static int alloc_list(struct net_device *dev)
 	return 0;
 }
 
-static int
-rio_open (struct net_device *dev)
+static void rio_hw_init(struct net_device *dev)
 {
 	struct netdev_private *np = netdev_priv(dev);
 	void __iomem *ioaddr = np->ioaddr;
-	const int irq = np->pdev->irq;
 	int i;
 	u16 macctrl;
 
-	i = alloc_list(dev);
-	if (i)
-		return i;
-
-	i = request_irq(irq, rio_interrupt, IRQF_SHARED, dev->name, dev);
-	if (i) {
-		free_list(dev);
-		return i;
-	}
-
 	/* Reset all logic functions */
 	dw16(ASICCtrl + 2,
 	     GlobalReset | DMAReset | FIFOReset | NetworkReset | HostReset);
@@ -560,6 +533,24 @@ rio_open (struct net_device *dev)
 	/* DebugCtrl bit 4, 5, 9 must set */
 	dw32(DebugCtrl, dr32(DebugCtrl) | 0x0230);
 
+	if (np->chip_id == CHIP_IP1000A &&
+	    (np->pdev->revision == 0x40 || np->pdev->revision == 0x41)) {
+		/* PHY magic taken from ipg driver, undocumented registers */
+		mii_write(dev, np->phy_addr, 31, 0x0001);
+		mii_write(dev, np->phy_addr, 27, 0x01e0);
+		mii_write(dev, np->phy_addr, 31, 0x0002);
+		mii_write(dev, np->phy_addr, 27, 0xeb8e);
+		mii_write(dev, np->phy_addr, 31, 0x0000);
+		mii_write(dev, np->phy_addr, 30, 0x005e);
+		/* advertise 1000BASE-T half & full duplex, prefer MASTER */
+		mii_write(dev, np->phy_addr, MII_CTRL1000, 0x0700);
+	}
+
+	if (np->phy_media)
+		mii_set_media_pcs(dev);
+	else
+		mii_set_media(dev);
+
 	/* Jumbo frame */
 	if (np->jumbo != 0)
 		dw16(MaxFrameSize, MAX_JUMBO+14);
@@ -602,10 +593,6 @@ rio_open (struct net_device *dev)
 		dw32(MACCtrl, dr32(MACCtrl) | AutoVLANuntagging);
 	}
 
-	setup_timer(&np->timer, rio_timer, (unsigned long)dev);
-	np->timer.expires = jiffies + 1*HZ;
-	add_timer (&np->timer);
-
 	/* Start Tx/Rx */
 	dw32(MACCtrl, dr32(MACCtrl) | StatsEnable | RxEnable | TxEnable);
 
@@ -615,6 +602,42 @@ rio_open (struct net_device *dev)
 	macctrl |= (np->tx_flow) ? TxFlowControlEnable : 0;
 	macctrl |= (np->rx_flow) ? RxFlowControlEnable : 0;
 	dw16(MACCtrl, macctrl);
+}
+
+static void rio_hw_stop(struct net_device *dev)
+{
+	struct netdev_private *np = netdev_priv(dev);
+	void __iomem *ioaddr = np->ioaddr;
+
+	/* Disable interrupts */
+	dw16(IntEnable, 0);
+
+	/* Stop Tx and Rx logics */
+	dw32(MACCtrl, TxDisable | RxDisable | StatsDisable);
+}
+
+static int rio_open(struct net_device *dev)
+{
+	struct netdev_private *np = netdev_priv(dev);
+	const int irq = np->pdev->irq;
+	int i;
+
+	i = alloc_list(dev);
+	if (i)
+		return i;
+
+	rio_hw_init(dev);
+
+	i = request_irq(irq, rio_interrupt, IRQF_SHARED, dev->name, dev);
+	if (i) {
+		rio_hw_stop(dev);
+		free_list(dev);
+		return i;
+	}
+
+	setup_timer(&np->timer, rio_timer, (unsigned long)dev);
+	np->timer.expires = jiffies + 1 * HZ;
+	add_timer(&np->timer);
 
 	netif_start_queue (dev);
 
@@ -1764,17 +1787,11 @@ static int
 rio_close (struct net_device *dev)
 {
 	struct netdev_private *np = netdev_priv(dev);
-	void __iomem *ioaddr = np->ioaddr;
-
 	struct pci_dev *pdev = np->pdev;
 
 	netif_stop_queue (dev);
 
-	/* Disable interrupts */
-	dw16(IntEnable, 0);
-
-	/* Stop Tx and Rx logics */
-	dw32(MACCtrl, TxDisable | RxDisable | StatsDisable);
+	rio_hw_stop(dev);
 
 	free_irq(pdev->irq, dev);
 	del_timer_sync (&np->timer);
-- 
Ondrej Zary


  reply	other threads:[~2015-11-17 17:29 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-11-17 17:28 [PATCH 1/3] dl2k: Handle memory allocation errors in alloc_list Ondrej Zary
2015-11-17 17:28 ` Ondrej Zary [this message]
2015-11-17 17:28 ` [PATCH 3/3] dl2k: Implement suspend Ondrej Zary
2015-11-17 22:56   ` Francois Romieu
2015-11-18  9:10     ` Ondrej Zary
2015-11-17 22:54 ` [PATCH 1/3] dl2k: Handle memory allocation errors in alloc_list Francois Romieu
2015-11-18  8:10   ` Ondrej Zary
  -- strict thread matches above, loose matches on Subject: below --
2015-11-18 21:36 [PATCH 1/3 v2] " Ondrej Zary
2015-11-18 21:36 ` [PATCH 2/3] dl2k: Reorder and cleanup initialization Ondrej Zary
2015-11-19 19:13 [PATCH 1/3 v2] dl2k: Handle memory allocation errors in alloc_list Ondrej Zary
2015-11-19 19:13 ` [PATCH 2/3] dl2k: Reorder and cleanup initialization Ondrej Zary
2015-11-20 19:49   ` David Miller

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1447781298-19785-2-git-send-email-linux@rainbow-software.org \
    --to=linux@rainbow-software.org \
    --cc=davem@davemloft.net \
    --cc=linux-kernel@vger.kernel.org \
    --cc=netdev@vger.kernel.org \
    --cc=romieu@fr.zoreil.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.