[PATCH 2/3] USB: mxu11x0: clean device control commands

[Mathieu OTHACEHE <m.othacehe@gmail.com>]

Sending OPEN and START commands twice is not necessary for this driver.
Also send STOP command at close.

Signed-off-by: Mathieu OTHACEHE <m.othacehe@gmail.com>
---
 drivers/usb/serial/mxu11x0.c | 31 +++++++------------------------
 1 file changed, 7 insertions(+), 24 deletions(-)

diff --git a/drivers/usb/serial/mxu11x0.c b/drivers/usb/serial/mxu11x0.c
index 0fe7eab..354fcb5 100644
--- a/drivers/usb/serial/mxu11x0.c
+++ b/drivers/usb/serial/mxu11x0.c
@@ -823,30 +823,6 @@ static int mxu1_open(struct tty_struct *tty, struct usb_serial_port *port)
 		goto unlink_int_urb;
 	}
 
-	/*
-	 * reset the data toggle on the bulk endpoints to work around bug in
-	 * host controllers where things get out of sync some times
-	 */
-	usb_clear_halt(serial->dev, port->write_urb->pipe);
-	usb_clear_halt(serial->dev, port->read_urb->pipe);
-
-	if (tty)
-		mxu1_set_termios(tty, port, NULL);
-
-	status = mxu1_send_ctrl_urb(serial, MXU1_OPEN_PORT,
-				    open_settings, MXU1_UART1_PORT);
-	if (status) {
-		dev_err(&port->dev, "cannot send open command: %d\n", status);
-		goto unlink_int_urb;
-	}
-
-	status = mxu1_send_ctrl_urb(serial, MXU1_START_PORT,
-				    0, MXU1_UART1_PORT);
-	if (status) {
-		dev_err(&port->dev, "cannot send start command: %d\n", status);
-		goto unlink_int_urb;
-	}
-
 	status = usb_serial_generic_open(tty, port);
 	if (status)
 		goto unlink_int_urb;
@@ -866,6 +842,13 @@ static void mxu1_close(struct usb_serial_port *port)
 	usb_serial_generic_close(port);
 	usb_kill_urb(port->interrupt_in_urb);
 
+	status = mxu1_send_ctrl_urb(port->serial, MXU1_STOP_PORT,
+				    0, MXU1_UART1_PORT);
+	if (status) {
+		dev_err(&port->dev, "failed to send stop port command: %d\n",
+			status);
+	}
+
 	status = mxu1_send_ctrl_urb(port->serial, MXU1_CLOSE_PORT,
 				    0, MXU1_UART1_PORT);
 	if (status) {
-- 
2.6.2