[U-Boot] [PATCH v2 0/7] net: add support for phy speed limitation

[Alexey Brodkin <Alexey.Brodkin@synopsys.com>]

Hi Joe,

On Tue, 2016-01-19 at 07:02 +0000, Alexey Brodkin wrote:
> Hi Joe,
> 
> On Wed, 2016-01-13 at 16:59 +0300, Alexey Brodkin wrote:
> > In some cases Ethernet PHY and network itself might support speeds
> > which are not supported by Ethernet controller (MAC).
> > 
> > To support that kind of situation it is required to force limit
> > PHY so it is not configured for unsupported mode or even if PHY 
> > autonegotiated too high speed it will be reconfigured for slower mode.
> > 
> > Note this series is v2 because v1 patches were sent separately not being
> > aranged in series. And now I'm putting all patches in one series
> > and marking it v2 even though no changes were done in patches itself.
> > 
> > Alexey Brodkin (4):
> >   drivers/net/phy: introduce phy_set_supported()
> >   include/net.h: add max_speed member in struct eth_pdata
> >   net/designware: do explicit port selection for 1Gb mode
> >   net/designware: add support of max-speed device tree property
> > 
> > Florian Fainelli (2):
> >   net: phy: ensure Gigabit features are masked off if requested
> >   net: phy: breakdown PHY_*_FEATURES defines
> > 
> > Sascha Hauer (1):
> >   net: phy: genphy: Allow overwriting features
> > 
> >  drivers/net/designware.c | 16 +++++++++-
> >  drivers/net/designware.h |  1 +
> >  drivers/net/phy/phy.c    | 77 ++++++++++++++++++++++++++++++++++--------------
> >  include/net.h            |  2 ++
> >  include/phy.h            | 23 ++++++++++-----
> >  5 files changed, 89 insertions(+), 30 deletions(-)
> 
> Please treat this as a polite reminder to review
> that series sometime soon.

Thank you for reviewing that series.
I'm wondering who's going to pick it up?

-Alexey