Re: [PATCH v3 0/3]

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Fri, 2016-07-15 at 19:01 +0800, Kefeng Wang wrote:
> Make dw8250_set_termios() as the default set_termios callback for 8250
> dw uart, correct me
> if I am wrong.
> 
> Then add ACPI support for uart on Hisilicon Hip05 soc, be careful that
> it is not 16500
> compatible. Meanwhile, set dw8250_serial_out32 to keep consistent
> between serial_out
> and serial_in in ACPI.

I will review it perhaps late this week.
Though have a quick question, did you test it? I hope you have done.

> 
> Change since v2:
> - Add a new patch to use new var dev in probe
> - Use built-in device properties to set device parameters for existing
> device probed by acpi,
>   suggested by Andy Shevchenko 
> 
> 
> Change since v1:
> - Use acpi_match_device() instead of acpi_dev_found(), limit the check
> to the device
>   being probed and not a global search for whole DSDT (pointed by grae
> me.gregory@linaro.org)
> 
> Kefeng Wang (3):
>   serial: 8250_dw: make dw8250_set_termios as default set_termios
>     callback
>   serial: 8250_dw: Use new dev variable in probe
>   serial: 8250_dw: add ACPI support for uart on Hisilicon Hip05 soc
> 
>  drivers/tty/serial/8250/8250_dw.c | 71 ++++++++++++++++++++++------
> -----------
>  1 file changed, 41 insertions(+), 30 deletions(-)
> 

-- 

Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Intel Finland Oy