Low network throughput on i.MX28

[joerg.krause@embedded.rocks (Jörg Krause)]

On Sat, 2016-11-05 at 12:39 +0000, Koul, Vinod wrote:
> On Sat, 2016-11-05 at 13:06 +0100, J?rg Krause wrote:
> > @ Vinod
> > In short, I noticed poor performance in the SSP2 (MMC/SD/SDIO)
> > interface on a custom i.MX28 board with a wifi chip attached.
> > Comparing
> > the bandwith with iperf I get >20Mbits/sec on the vendor kernel and
> > <5Mbits/sec on the mainline kernel. I am trying to investigate what
> > the
> > bottleneck is.
> 
> is this imx-dma or imx-sdma..

Its' mxs-dma.

> 
> > 
> > @ Stefan, all
> > My understanding is that the tasklet in this case is responsible
> > for
> > reading the response registers of the DMA controller and return the
> > response to the MMC host driver.
> > 
> > The vendor kernel does this in the interrupt routine of mxs-mmc by
> > issueing a complete whereas the mainline kernel does this in the
> > interrupt routine in mxs-dma by scheduling the tasklet.
> 
> Is vendor kernel using dmaengine APIs or not?

No. It's using a custom dmaengine.

> 
> Okay, if we talk about getting best performance, I always advise
> folks
> to issue next transaction in the interrupt routine and then do
> descriptor management and callback in tasklet.
> 
> Some drivers do that correctly but some don't..

Do you have an example for a driver doing it correctly?

> Tasklet can be an issue but only if there is a huge scheduling delay
> for
> the tasklet. You can check using tracing tools and confirm.

Don't think the tasklets is an issue here as I replaced the tasklets in
the dmaengine API by completion (which the vendor kernel uses) and
there are no performance benefits. However, I am not a Linux kernel
developer...

J?rg