Re: [PATCH v1 1/1] pinctrl: intel: Set pin direction properly

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Wed, 2017-01-11 at 13:50 +0100, Linus Walleij wrote:
> On Mon, Jan 2, 2017 at 1:07 PM, Andy Shevchenko
> <andriy.shevchenko@linux.intel.com> wrote:
> 
> > There are two bits in the PADCFG0 register to configure direction,
> > one per
> > TX/RX buffers.
> > 
> > For now we wrongly assume that the GPIO is always requested before
> > it is being
> > used, which is not true when the GPIO is used through irqchip. In
> > this case the
> > GPIO is never requested and we never enable RX buffer for it.
> > 
> > Fix this by setting both bits accordingly.
> > 
> > Reported-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>
> > Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
> 
> I applied this patch for fixes on top of Mika's pad offset
> fix.
> 
> Hope this is right... There is some noise in the thread but
> AFAICT there are more fixes coming.

Yes, it's self-sufficient and needed independently of the rest.
Thanks!

-- 
Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Intel Finland Oy