Re: [PATCH v2] ceph/iov_iter: fix bad iov_iter handling in ceph splice codepaths

[Jeff Layton <jlayton@redhat.com>]

On Thu, 2017-01-12 at 12:46 +0100, Ilya Dryomov wrote:
> On Thu, Jan 12, 2017 at 12:37 PM, Al Viro <viro@zeniv.linux.org.uk> wrote:
> > 
> > On Thu, Jan 12, 2017 at 12:13:31PM +0100, Ilya Dryomov wrote:
> > 
> > > 
> > > It would be a significant and wide-reaching change, but I've been
> > > meaning to look into switching to iov_iter for a couple of releases
> > > now.  There is a lot of ugly code in net/ceph/messenger.c to hangle
> > > iteration over "page vectors", "page lists" and "bio lists".  All of it
> > > predates iov_iter proliferation and is mostly incomplete anyway: IIRC
> > > you can send out of a pagelist but can't recv into a pagelist, etc.
> > 
> > Wait a sec...  Is it done from the same thread that has issued a syscall?
> > If so, we certainly could just pass iov_iter without bothering with any
> > form of ..._get_pages(); if not, we'll need at least to get from iovec
> > to bio_vec, since userland addresses make sense only in the caller's
> > context...
> 
> No, not necessarily - it's also used by rbd (all of net/ceph has two
> users: fs/ceph and drivers/block/rbd.c).
> 
> 

...and note that the actual send/receive is done from workqueue context
(AFAICT), so we might be operating over the array from a completely
different thread context from where it was submitted. I think we do need
to get page references at the point of submission like this.
-- 
Jeff Layton <jlayton@redhat.com>