Re: [PATCH] cxgbit: use T6 specific macro to set force bit

[Joe Perches <joe@perches.com>]

On Wed, 2017-01-25 at 12:08 +0530, Varun Prakash wrote:
> On Wed, Jan 25, 2017 at 02:41:40AM +0530, Joe Perches wrote:
> > On Tue, 2017-01-24 at 17:07 +0530, Varun Prakash wrote:
> > > For T6 adapters use T6 specific macro to set
> > > force bit.
> > 
> > []
> > > diff --git a/drivers/net/ethernet/chelsio/cxgb4/t4_msg.h b/drivers/net/ethernet/chelsio/cxgb4/t4_msg.h
> > 
> > []
> > > @@ -1349,6 +1349,10 @@ struct cpl_tx_data {
> > >  #define TX_FORCE_S	13
> > >  #define TX_FORCE_V(x)	((x) << TX_FORCE_S)
> > >  
> > > +#define T6_TX_FORCE_S		20
> > > +#define T6_TX_FORCE_V(x)	((x) << T6_TX_FORCE_S)
> > > +#define T6_TX_FORCE_F		T6_TX_FORCE_V(1U)
> > > +
> > >  enum {
> > >  	ULP_TX_MEM_READ = 2,
> > >  	ULP_TX_MEM_WRITE = 3,
> > > diff --git a/drivers/target/iscsi/cxgbit/cxgbit_target.c b/drivers/target/iscsi/cxgbit/cxgbit_target.c
> > 
> > []
> > > @@ -162,12 +162,14 @@ cxgbit_tx_data_wr(struct cxgbit_sock *csk, struct sk_buff *skb, u32 dlen,
> > >  		  u32 len, u32 credits, u32 compl)
> > >  {
> > >  	struct fw_ofld_tx_data_wr *req;
> > > +	const struct cxgb4_lld_info *lldi = &csk->com.cdev->lldi;
> > >  	u32 submode = cxgbit_skcb_submode(skb);
> > >  	u32 wr_ulp_mode = 0;
> > >  	u32 hdr_size = sizeof(*req);
> > >  	u32 opcode = FW_OFLD_TX_DATA_WR;
> > >  	u32 immlen = 0;
> > > -	u32 force = TX_FORCE_V(!submode);
> > > +	u32 force = is_t5(lldi->adapter_type) ? TX_FORCE_V(!submode) :
> > > +		    T6_TX_FORCE_F;
> > 
> > Perhaps it'd be better to add a is_t6() mechanism so this
> > is written in the positive rather than the negative.
> > 
> 
> At present

That's the key phrase that describes the reason why it's
generally better to write code in the positive than the
negative.

> cxgbit driver supports only T5 and T6 adapters so
> if a adapter is not T5 then it is T6.

Your code, your choices...