diff for duplicates of <1489582.v1309hbNQ9@avalon> diff --git a/a/1.txt b/N1/1.txt index b1e48ae..7752a09 100644 --- a/a/1.txt +++ b/N1/1.txt @@ -42,7 +42,7 @@ On Wednesday 12 June 2013 15:36:59 James Hogan wrote: > > pin controller device. > > > > + -> > += Generic pinconf parameters = +> > +== Generic pinconf parameters == > > + > > +Pin configuration parameters are expressed by DT properties in the pin > > +controller device state nodes and child nodes. For devices that use the @@ -77,7 +77,7 @@ pull-up and pull-down values, as explained below) ? > it is 0, pull-up is disabled", so I think these should be flags unless > it's changed there first. -= 0 for disabled and != 0 for enabled doesn't mean that all != 0 values are +== 0 for disabled and != 0 for enabled doesn't mean that all != 0 values are equivalent. As I read it drivers can use the value to control the pull-up/down strength without violating the documentation. diff --git a/a/content_digest b/N1/content_digest index 5f211cb..59eea8e 100644 --- a/a/content_digest +++ b/N1/content_digest @@ -2,7 +2,7 @@ "ref\051B8878B.5090705@imgtec.com\0" "From\0Laurent Pinchart <laurent.pinchart@ideasonboard.com>\0" "Subject\0Re: [RFC] pinctrl: generic: Add DT bindings\0" - "Date\0Thu, 13 Jun 2013 22:46:11 +0000\0" + "Date\0Fri, 14 Jun 2013 00:46:11 +0200\0" "To\0James Hogan <james.hogan@imgtec.com>\0" "Cc\0Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>" linux-kernel@vger.kernel.org @@ -55,7 +55,7 @@ "> > pin controller device.\n" "> > \n" "> > +\n" - "> > += Generic pinconf parameters =\n" + "> > +== Generic pinconf parameters ==\n" "> > +\n" "> > +Pin configuration parameters are expressed by DT properties in the pin\n" "> > +controller device state nodes and child nodes. For devices that use the\n" @@ -90,7 +90,7 @@ "> it is 0, pull-up is disabled\", so I think these should be flags unless\n" "> it's changed there first.\n" "\n" - "= 0 for disabled and != 0 for enabled doesn't mean that all != 0 values are \n" + "== 0 for disabled and != 0 for enabled doesn't mean that all != 0 values are \n" "equivalent. As I read it drivers can use the value to control the pull-up/down \n" "strength without violating the documentation.\n" "\n" @@ -141,4 +141,4 @@ "\n" Laurent Pinchart -1dd2f269f9bb3e9baf85220bee627e1f687394b30fbd2b12e2bde19aa1d82163 +444d4db3c794505ab77e483e0de38a14e01022304d6b00815ec82ebd81343b16
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.