Re: [RFC 60g 2/5] wireless: rate check logic for 60g

[Vladimir Kondratiev <vkondrat@qualcomm.com>]

On Thursday, June 28, 2012 08:04:24 PM Johannes Berg wrote:
> On Thu, 2012-06-28 at 14:16 +0300, Vladimir Kondratiev wrote:
> > +		/*
> > +		 * on 60gHz band, there are no legacy rates, so
> > +		 * n_bitrates is 0
> > +		 */
> > +		if (WARN_ON((band != IEEE80211_BAND_60GHZ) &&
> > +		    !sband->n_bitrates))
> > 
> >  			return -EINVAL;
> 
> Please fix indentation.
> 
> johannes

I am confused a bit. What is "proper" identation for this case
(wrapped expression)?
Immediately following code use same identation (4 spaces).

		if (cfg80211_disable_40mhz_24ghz &&
		    band == IEEE80211_BAND_2GHZ &&
		    sband->ht_cap.ht_supported) {
			sband->ht_cap.cap &= ~IEEE80211_HT_CAP_SUP_WIDTH_20_40;
			sband->ht_cap.cap &= ~IEEE80211_HT_CAP_SGI_40;
		}

Should I ident line containing (see above):
!sband->n_bitrates))
with:
 - 4 spaces as next code fragment,
 - one tab (same level as 'return')
 - 2 tabs (one level more then 'return')
 - other (what?)