All of lore.kernel.org
 help / color / mirror / Atom feed
From: Tim Harvey <tharvey@gateworks.com>
To: linux-media@vger.kernel.org
Cc: devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
	shawnguo@kernel.org, Steve Longerbeam <slongerbeam@gmail.com>,
	Philipp Zabel <p.zabel@pengutronix.de>,
	Hans Verkuil <hansverk@cisco.com>,
	Mauro Carvalho Chehab <mchehab@s-opensource.com>
Subject: [PATCH 4/4] ARM: DTS: imx: ventana: add TDA19971 HDMI Receiver to GW54xx
Date: Fri, 22 Sep 2017 15:24:13 -0700	[thread overview]
Message-ID: <1506119053-21828-5-git-send-email-tharvey@gateworks.com> (raw)
In-Reply-To: <1506119053-21828-1-git-send-email-tharvey@gateworks.com>

The GW54xx has a front-panel microHDMI connector routed to a TDA19971
which is connected the the IPU CSI when using IMX6Q.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
---
 arch/arm/boot/dts/imx6q-gw54xx.dts | 85 ++++++++++++++++++++++++++++++++++++++
 1 file changed, 85 insertions(+)

diff --git a/arch/arm/boot/dts/imx6q-gw54xx.dts b/arch/arm/boot/dts/imx6q-gw54xx.dts
index 56e5b50..efb7dd3 100644
--- a/arch/arm/boot/dts/imx6q-gw54xx.dts
+++ b/arch/arm/boot/dts/imx6q-gw54xx.dts
@@ -12,6 +12,7 @@
 /dts-v1/;
 #include "imx6q.dtsi"
 #include "imx6qdl-gw54xx.dtsi"
+#include <dt-bindings/media/tda1997x.h>
 
 / {
 	model = "Gateworks Ventana i.MX6 Dual/Quad GW54XX";
@@ -35,6 +36,60 @@
 			};
 		};
 	};
+
+	tda1997x: tda1997x@48 {
+		compatible = "nxp,tda19971";
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_tda1997x>;
+		reg = <0x48>;
+		interrupt-parent = <&gpio1>;
+		interrupts = <7 IRQ_TYPE_LEVEL_LOW>;
+		DOVDD-supply = <&reg_3p3v>;
+		AVDD-supply = <&sw4_reg>;
+		DVDD-supply = <&sw4_reg>;
+		audio-port = < TDA1997X_I2S16
+		               TDA1997X_LAYOUT0
+			       TDA1997X_ACLK_128FS >;
+		/*
+		 * The 8bpp YUV422 semi-planar mode outputs CbCr[11:4]
+		 * and Y[11:4] across 16bits in the same cycle
+		 * which we map to VP[15:08]<->CSI_DATA[19:12]
+		 */
+		vidout_portcfg =
+			/*G_Y_11_8<->VP[15:12]<->CSI_DATA[19:16]*/
+			< TDA1997X_VP24_V15_12 TDA1997X_G_Y_11_8 >,
+			/*G_Y_7_4<->VP[11:08]<->CSI_DATA[15:12]*/
+			< TDA1997X_VP24_V11_08 TDA1997X_G_Y_7_4 >,
+			/*R_CR_CBCR_11_8<->VP[07:04]<->CSI_DATA[11:08]*/
+			< TDA1997X_VP24_V07_04 TDA1997X_R_CR_CBCR_11_8 >,
+			/*R_CR_CBCR_7_4<->VP[03:00]<->CSI_DATA[07:04]*/
+			< TDA1997X_VP24_V03_00 TDA1997X_R_CR_CBCR_7_4 >;
+		max-pixel-rate = <180>; /* IMX6 CSI max pixel rate 180MP/sec */
+
+		port {
+			tda1997x_to_ipu1_csi0_mux: endpoint {
+				remote-endpoint = <&ipu1_csi0_mux_from_parallel_sensor>;
+				bus-width = <16>;
+				hsync-active = <1>;
+				vsync-active = <1>;
+				data-active = <1>;
+			};
+		};
+	};
+};
+
+&ipu1_csi0_from_ipu1_csi0_mux {
+	bus-width = <16>;
+};
+
+&ipu1_csi0_mux_from_parallel_sensor {
+	remote-endpoint = <&tda1997x_to_ipu1_csi0_mux>;
+	bus-width = <16>;
+};
+
+&ipu1_csi0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_ipu1_csi0>;
 };
 
 &ipu2_csi1_from_ipu2_csi1_mux {
@@ -63,6 +118,30 @@
 		>;
 	};
 
+	pinctrl_ipu1_csi0: ipu1_csi0grp {
+		fsl,pins = <
+			MX6QDL_PAD_CSI0_DAT4__IPU1_CSI0_DATA04		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT5__IPU1_CSI0_DATA05		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT6__IPU1_CSI0_DATA06		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT7__IPU1_CSI0_DATA07		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT8__IPU1_CSI0_DATA08		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT9__IPU1_CSI0_DATA09		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT10__IPU1_CSI0_DATA10		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT11__IPU1_CSI0_DATA11		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT12__IPU1_CSI0_DATA12		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT13__IPU1_CSI0_DATA13		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT14__IPU1_CSI0_DATA14		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT15__IPU1_CSI0_DATA15		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT16__IPU1_CSI0_DATA16		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT17__IPU1_CSI0_DATA17		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT18__IPU1_CSI0_DATA18		0x1b0b0
+			MX6QDL_PAD_CSI0_DAT19__IPU1_CSI0_DATA19		0x1b0b0
+			MX6QDL_PAD_CSI0_MCLK__IPU1_CSI0_HSYNC		0x1b0b0
+			MX6QDL_PAD_CSI0_PIXCLK__IPU1_CSI0_PIXCLK	0x1b0b0
+			MX6QDL_PAD_CSI0_VSYNC__IPU1_CSI0_VSYNC		0x1b0b0
+		>;
+	};
+
 	pinctrl_ipu2_csi1: ipu2_csi1grp {
 		fsl,pins = <
 			MX6QDL_PAD_EIM_EB2__IPU2_CSI1_DATA19    0x1b0b0
@@ -78,4 +157,10 @@
 			MX6QDL_PAD_EIM_A16__IPU2_CSI1_PIXCLK    0x1b0b0
 		>;
 	};
+
+	pinctrl_tda1997x: tda1997xgrp {
+		fsl,pins = <
+			MX6QDL_PAD_GPIO_7__GPIO1_IO07	0x1b0b0
+		>;
+	};
 };
-- 
2.7.4

      parent reply	other threads:[~2017-09-22 22:24 UTC|newest]

Thread overview: 12+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2017-09-22 22:24 [PATCH 0/4] RFC: TDA1997x HDMI video receiver Tim Harvey
2017-09-22 22:24 ` Tim Harvey
2017-09-22 22:24 ` [PATCH 1/4] MAINTAINERS: add entry for NXP TDA1997x driver Tim Harvey
2017-09-22 22:24 ` [PATCH 2/4] media: dt-bindings: Add bindings for TDA1997X Tim Harvey
2017-10-04 21:14   ` Rob Herring
2017-10-05 17:06     ` Tim Harvey
     [not found] ` <1506119053-21828-1-git-send-email-tharvey-UMMOYl/HMS+akBO8gow8eQ@public.gmane.org>
2017-09-22 22:24   ` [PATCH 3/4] media: i2c: Add TDA1997x HDMI receiver driver Tim Harvey
2017-09-22 22:24     ` Tim Harvey
     [not found]     ` <1506119053-21828-4-git-send-email-tharvey-UMMOYl/HMS+akBO8gow8eQ@public.gmane.org>
2017-09-23  7:30       ` Hans Verkuil
2017-09-23  7:30         ` Hans Verkuil
2017-09-25 20:44         ` Tim Harvey
2017-09-22 22:24 ` Tim Harvey [this message]

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1506119053-21828-5-git-send-email-tharvey@gateworks.com \
    --to=tharvey@gateworks.com \
    --cc=devicetree@vger.kernel.org \
    --cc=hansverk@cisco.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-media@vger.kernel.org \
    --cc=mchehab@s-opensource.com \
    --cc=p.zabel@pengutronix.de \
    --cc=shawnguo@kernel.org \
    --cc=slongerbeam@gmail.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.