[U-Boot] [PATCH v4 1/7] arm: vf610: Add IOMUX support for Vybrid VF610

["Benoît Thébaudeau" <benoit.thebaudeau@advansee.com>]

Hi Alison,

On Tuesday, May 28, 2013 10:55:41 AM, Alison Wang wrote:
> This patch adds the IOMUX support for Vybrid VF610 platform.
> 
> There is a little difference for IOMUXC module between VF610 and i.MX
> platform, the muxmode and pad configuration share one 32bit register on
> VF610, but they are two independent registers on I.MX platform. A
> CONFIG_IOMUX_SHARE_CONFIG_REG was introduced to fit this difference.
> 
> Signed-off-by: Alison Wang <b18965@freescale.com>

[...]

> diff --git a/arch/arm/imx-common/iomux-v3.c b/arch/arm/imx-common/iomux-v3.c
> index 7fe5ce7..35880c7 100644
> --- a/arch/arm/imx-common/iomux-v3.c
> +++ b/arch/arm/imx-common/iomux-v3.c
> @@ -48,8 +48,14 @@ void imx_iomux_v3_setup_pad(iomux_v3_cfg_t pad)
>  	if (sel_input_ofs)
>  		__raw_writel(sel_input, base + sel_input_ofs);
>  
> +#ifdef CONFIG_IOMUX_SHARE_CONF_REG

Where is this one defined? I don't see it in include/configs/vf610twr.h.

Why not use "#ifdef CONFIG_VF610" since this is a platform-dependent code, and
not a board-specific config option?

> +	if (!(pad_ctrl & NO_PAD_CTRL))
> +		__raw_writel((mux_mode << PAD_MUX_MODE_SHIFT) | pad_ctrl,
> +			base + pad_ctrl_ofs);
> +#else
>  	if (!(pad_ctrl & NO_PAD_CTRL) && pad_ctrl_ofs)
>  		__raw_writel(pad_ctrl, base + pad_ctrl_ofs);
> +#endif
>  }
>  
>  void imx_iomux_v3_setup_multiple_pads(iomux_v3_cfg_t const *pad_list,

[...]

Apart from that, this patch is OK.

Best regards,
Beno?t