Re: TCP and BBR: reproducibly low cwnd and bandwidth

[Eric Dumazet <eric.dumazet@gmail.com>]

Lets CC BBR folks at Google, and remove the ones that probably have no
idea.



On Thu, 2018-02-15 at 21:42 +0100, Oleksandr Natalenko wrote:
> Hello.
> 
> I've faced an issue with a limited TCP bandwidth between my laptop and a 
> server in my 1 Gbps LAN while using BBR as a congestion control mechanism. To 
> verify my observations, I've set up 2 KVM VMs with the following parameters:
> 
> 1) Linux v4.15.3
> 2) virtio NICs
> 3) 128 MiB of RAM
> 4) 2 vCPUs
> 5) tested on both non-PREEMPT/100 Hz and PREEMPT/1000 Hz
> 
> The VMs are interconnected via host bridge (-netdev bridge). I was running 
> iperf3 in the default and reverse mode. Here are the results:
> 
> 1) BBR on both VMs
> 
> upload: 3.42 Gbits/sec, cwnd ~ 320 KBytes
> download: 3.39 Gbits/sec, cwnd ~ 320 KBytes
> 
> 2) Reno on both VMs
> 
> upload: 5.50 Gbits/sec, cwnd = 976 KBytes (constant)
> download: 5.22 Gbits/sec, cwnd = 1.20 MBytes (constant)
> 
> 3) Reno on client, BBR on server
> 
> upload: 5.29 Gbits/sec, cwnd = 952 KBytes (constant)
> download: 3.45 Gbits/sec, cwnd ~ 320 KBytes
> 
> 4) BBR on client, Reno on server
> 
> upload: 3.36 Gbits/sec, cwnd ~ 370 KBytes
> download: 5.21 Gbits/sec, cwnd = 887 KBytes (constant)
> 
> So, as you may see, when BBR is in use, upload rate is bad and cwnd is low. If 
> using real HW (1 Gbps LAN, laptop and server), BBR limits the throughput to 
> ~100 Mbps (verifiable not only by iperf3, but also by scp while transferring 
> some files between hosts).
> 
> Also, I've tried to use YeAH instead of Reno, and it gives me the same results 
> as Reno (IOW, YeAH works fine too).
> 
> Questions:
> 
> 1) is this expected?
> 2) or am I missing some extra BBR tuneable?
> 3) if it is not a regression (I don't have any previous data to compare with), 
> how can I fix this?
> 4) if it is a bug in BBR, what else should I provide or check for a proper 
> investigation?
> 
> Thanks.
> 
> Regards,
>   Oleksandr
> 
>