Re: [PATCH] ahci: Improve error handling

[Paul Menzel <paulepanter@users.sourceforge.net>]

[-- Attachment #1: Type: text/plain, Size: 2018 bytes --]

Dear Stefan,


Am Montag, den 29.01.2018, 13:16 +0100 schrieb Daniel Kiper:
> On Tue, Jan 23, 2018 at 01:00:56PM +0100, Daniel Kiper wrote:
> > On Fri, Jan 19, 2018 at 02:13:29PM +0100, Stefan Fritsch wrote:
> > > From: Stefan Fritsch <fritsch@genua.de>
> > > 
> > > Check the error bits in the interrupt status register. According to the
> > > AHCI 1.2 spec, "Interrupt sources that are disabled (?0?) are still
> > > reflected in the status registers.", so this should work even though
> > > grub uses polling
> > > 
> > > This fixes the following problem on a Fujitsu E744 laptop:
> > > 
> > > Sometimes there is a very long delay (up to several minutes) when
> > > booting from hard disk. It seems accessing the DVD drive (which has no
> > > disk inserted) sometimes fails with some errors, which leads to each
> > > access being stalled until the 20s timeout triggers. This seems to
> > > happen when grub is trying to read filesystem/partition data.
> > > 
> > > The problem is that the command_issue bit that is checked in the loop is
> > > only reset if the "HBA receives a FIS which clears the BSY, DRQ, and ERR
> > > bits for the command", but the ERR bit is never cleared. Therefore
> > > command_issue is never reset and grub waits for the timeout.
> > > 
> > > The relevant bit in our case is the Task File Error Status (TFES), which
> > > is equivalent to the ERR bit 0 in tfd. But this patch also checks
> > > the other error bits except for the "Interface non-fatal error status"
> > > bit.
> > > 
> > > Signed-off-by: Stefan Fritsch <fritsch@genua.de>
> > 
> > Reviewed-by: Daniel Kiper <daniel.kiper@oracle.com>
> > 
> > If there are no objections I will apply this by the end of this week.
> 
> Applied!

This is just a note, that in #coreboot@freenode.net, a Lenovo T420 with
coreboot user reported this error with GRUB 2.02 (due to the DVD
drive), and building the master branch with your commit solved the
issue. Thank you very much.


Thanks,

Paul

[-- Attachment #2: This is a digitally signed message part --]
[-- Type: application/pgp-signature, Size: 195 bytes --]