From: Wesley Cheng <wcheng@codeaurora.org>
To: agross@kernel.org, bjorn.andersson@linaro.org, kishon@ti.com,
vkoul@kernel.org
Cc: linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org,
Wesley Cheng <wcheng@codeaurora.org>
Subject: [PATCH v2] phy: qcom-snps: Add runtime suspend and resume handlers
Date: Thu, 21 May 2020 18:50:00 -0700 [thread overview]
Message-ID: <1590112200-1110-1-git-send-email-wcheng@codeaurora.org> (raw)
Allow for the PHY to be put into a powered down state when possible.
Add the required suspend and resume callbacks, which will determine
what resources can be turned off depending on the cable status.
Signed-off-by: Wesley Cheng <wcheng@codeaurora.org>
---
Changes in v2:
- Addressed checkpatch alignment/line length warnings.
- Removed superfluous init in qcom_snps_hsphy_resume().
drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c | 100 ++++++++++++++++++++++++++
1 file changed, 100 insertions(+)
diff --git a/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c b/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
index 4d74045..0a4e77af 100644
--- a/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
+++ b/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
@@ -76,7 +76,9 @@
* @iface_clk: phy interface clock
* @phy_reset: phy reset control
* @vregs: regulator supplies bulk data
+ * @suspended: PHY is in the suspended state
* @phy_initialized: if PHY has been initialized correctly
+ * @mode: contains the current mode the PHY is in
*/
struct qcom_snps_hsphy {
struct phy *phy;
@@ -87,7 +89,9 @@ struct qcom_snps_hsphy {
struct reset_control *phy_reset;
struct regulator_bulk_data vregs[SNPS_HS_NUM_VREGS];
+ bool suspended;
bool phy_initialized;
+ enum phy_mode mode;
};
static inline void qcom_snps_hsphy_write_mask(void __iomem *base, u32 offset,
@@ -104,6 +108,84 @@ static inline void qcom_snps_hsphy_write_mask(void __iomem *base, u32 offset,
readl_relaxed(base + offset);
}
+static int qcom_snps_hsphy_suspend(struct qcom_snps_hsphy *hsphy)
+{
+ if (hsphy->suspended)
+ return 0;
+
+ dev_dbg(&hsphy->phy->dev, "Suspend QCOM SNPS PHY, mode:%d\n",
+ hsphy->mode);
+
+ if (hsphy->mode == PHY_MODE_USB_HOST) {
+ /* Enable auto-resume to meet remote wakeup timing */
+ qcom_snps_hsphy_write_mask(hsphy->base,
+ USB2_PHY_USB_PHY_HS_PHY_CTRL2,
+ USB2_AUTO_RESUME,
+ USB2_AUTO_RESUME);
+ usleep_range(500, 1000);
+ qcom_snps_hsphy_write_mask(hsphy->base,
+ USB2_PHY_USB_PHY_HS_PHY_CTRL2,
+ 0, USB2_AUTO_RESUME);
+ }
+
+ clk_disable_unprepare(hsphy->cfg_ahb_clk);
+ hsphy->suspended = true;
+
+ return 0;
+}
+
+static int qcom_snps_hsphy_resume(struct qcom_snps_hsphy *hsphy)
+{
+ int ret;
+
+ if (!hsphy->suspended)
+ return 0;
+
+ dev_dbg(&hsphy->phy->dev, "Resume QCOM SNPS PHY, mode:%d\n",
+ hsphy->mode);
+
+ ret = clk_prepare_enable(hsphy->cfg_ahb_clk);
+ if (ret) {
+ dev_err(&hsphy->phy->dev,
+ "failed to enable cfg ahb clock, %d\n", ret);
+ return ret;
+ }
+
+ hsphy->suspended = false;
+ return 0;
+}
+
+static int __maybe_unused qcom_snps_hsphy_runtime_suspend(struct device *dev)
+{
+ struct qcom_snps_hsphy *hsphy = dev_get_drvdata(dev);
+
+ if (!hsphy->phy_initialized)
+ return 0;
+
+ qcom_snps_hsphy_suspend(hsphy);
+ return 0;
+}
+
+static int __maybe_unused qcom_snps_hsphy_runtime_resume(struct device *dev)
+{
+ struct qcom_snps_hsphy *hsphy = dev_get_drvdata(dev);
+
+ if (!hsphy->phy_initialized)
+ return 0;
+
+ qcom_snps_hsphy_resume(hsphy);
+ return 0;
+}
+
+static int qcom_snps_hsphy_set_mode(struct phy *phy, enum phy_mode mode,
+ int submode)
+{
+ struct qcom_snps_hsphy *hsphy = phy_get_drvdata(phy);
+
+ hsphy->mode = mode;
+ return 0;
+}
+
static int qcom_snps_hsphy_init(struct phy *phy)
{
struct qcom_snps_hsphy *hsphy = phy_get_drvdata(phy);
@@ -175,6 +257,7 @@ static int qcom_snps_hsphy_init(struct phy *phy)
UTMI_PHY_CMN_CTRL_OVERRIDE_EN, 0);
hsphy->phy_initialized = true;
+ hsphy->suspended = false;
return 0;
@@ -201,6 +284,7 @@ static int qcom_snps_hsphy_exit(struct phy *phy)
static const struct phy_ops qcom_snps_hsphy_gen_ops = {
.init = qcom_snps_hsphy_init,
.exit = qcom_snps_hsphy_exit,
+ .set_mode = qcom_snps_hsphy_set_mode,
.owner = THIS_MODULE,
};
@@ -212,6 +296,11 @@ static int qcom_snps_hsphy_exit(struct phy *phy)
};
MODULE_DEVICE_TABLE(of, qcom_snps_hsphy_of_match_table);
+static const struct dev_pm_ops qcom_snps_hsphy_pm_ops = {
+ SET_RUNTIME_PM_OPS(qcom_snps_hsphy_runtime_suspend,
+ qcom_snps_hsphy_runtime_resume, NULL)
+};
+
static int qcom_snps_hsphy_probe(struct platform_device *pdev)
{
struct device *dev = &pdev->dev;
@@ -255,6 +344,14 @@ static int qcom_snps_hsphy_probe(struct platform_device *pdev)
return ret;
}
+ pm_runtime_set_active(dev);
+ pm_runtime_enable(dev);
+ /*
+ * Prevent runtime pm from being ON by default. Users can enable
+ * it using power/control in sysfs.
+ */
+ pm_runtime_forbid(dev);
+
generic_phy = devm_phy_create(dev, NULL, &qcom_snps_hsphy_gen_ops);
if (IS_ERR(generic_phy)) {
ret = PTR_ERR(generic_phy);
@@ -269,6 +366,8 @@ static int qcom_snps_hsphy_probe(struct platform_device *pdev)
phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
if (!IS_ERR(phy_provider))
dev_dbg(dev, "Registered Qcom-SNPS HS phy\n");
+ else
+ pm_runtime_disable(dev);
return PTR_ERR_OR_ZERO(phy_provider);
}
@@ -277,6 +376,7 @@ static int qcom_snps_hsphy_probe(struct platform_device *pdev)
.probe = qcom_snps_hsphy_probe,
.driver = {
.name = "qcom-snps-hs-femto-v2-phy",
+ .pm = &qcom_snps_hsphy_pm_ops,
.of_match_table = qcom_snps_hsphy_of_match_table,
},
};
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
next reply other threads:[~2020-05-22 1:50 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-05-22 1:50 Wesley Cheng [this message]
2020-06-24 12:21 ` [PATCH v2] phy: qcom-snps: Add runtime suspend and resume handlers Vinod Koul
2020-06-25 19:22 ` Wesley Cheng
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1590112200-1110-1-git-send-email-wcheng@codeaurora.org \
--to=wcheng@codeaurora.org \
--cc=agross@kernel.org \
--cc=bjorn.andersson@linaro.org \
--cc=kishon@ti.com \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=vkoul@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.