[PATCH v5 2/2] scsi: ufs-qcom: Fix ufs RST_n specs violation

[Ziqi Chen <ziqichen@codeaurora.org>]

As per specs, e.g, JESD220E chapter 7.2, while powering
off/on the ufs device, RST_n signal should be between
VSS(Ground) and VCCQ/VCCQ2.

Signed-off-by: Ziqi Chen <ziqichen@codeaurora.org>
---
 drivers/scsi/ufs/ufs-qcom.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
index 2206b1e..d8b896c 100644
--- a/drivers/scsi/ufs/ufs-qcom.c
+++ b/drivers/scsi/ufs/ufs-qcom.c
@@ -582,6 +582,10 @@ static int ufs_qcom_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 		ufs_qcom_disable_lane_clks(host);
 		phy_power_off(phy);
 
+		/* reset the connected UFS device during power down */
+		if (host->device_reset)
+			gpiod_set_value_cansleep(host->device_reset, 1);
+
 	} else if (!ufs_qcom_is_link_active(hba)) {
 		ufs_qcom_disable_lane_clks(host);
 	}
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project