From mboxrd@z Thu Jan 1 00:00:00 1970 From: Sujith Date: Fri, 21 Nov 2008 07:09:18 +0530 Subject: [ath9k-devel] It Works! In-Reply-To: <4925FAF0.3040202@astronomicalresearchaustralia.org> References: <20081119174129.GA14050@parabola.pavlovmedia.corp> <1227117298.4992.2.camel@jm-desktop> <20081119175817.GA3131@parabola.pavlovmedia.corp> <49249490.6090002@astronomicalresearchaustralia.org> <20081120035255.GJ5900@tesla> <4925FAF0.3040202@astronomicalresearchaustralia.org> Message-ID: <18726.4422.322793.34364@localhost.localdomain> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ath9k-devel@lists.ath9k.org Brian wrote: > Did a recompile after carefully checking menuconfig again. > The only major thing I have done is to remove any reference to IPV6. > > Rebooted and everything came up and WORKED!:) > Not sure what you changed but it has done the trick. > > I have been up for about 30mins with no issues. > 2.6.28-rc5-wl-W #11 SMP > > With this result > Mode Rate (Mbps) Signal (%) > 802.11n (2.4GHz) 78 100 > > > So while I am happy the 11n is now working the rate does not seem to be > as expected. > I am assuming you are using HT20 ? > ISSUES so far > > 1) When I do a ping there is about a 10-15sec delay before the responses > start coming back. > This is an issue, and we are looking into this. > 2) I cannot start WPA_GUI or WPA_CLI it comes back with > Selected interface 'wlan0.pid' > Trying to connect to '/var/run/wpa_supplicant/wlan0.pid' > Failed to open control connection to wpa_supplicant. > PING failed - trying to reconnect Can you show your wpa_supplicant config ? Sujith -- http://sujith-m.blogspot.com