From mboxrd@z Thu Jan 1 00:00:00 1970 Message-Id: <199905061917.MAA10016@soda.CSUA.Berkeley.EDU> To: Brad Boyer CC: linuxppc-dev@lists.linuxppc.org Subject: Re: USB under LinuxPPC In-Reply-To: Your message of "Wed, 05 May 1999 22:29:23 CDT." <199905060329.WAA28970@cegt201.bradley.edu> Date: Thu, 06 May 1999 12:17:39 -0700 From: Sriranga Veeraraghavan Sender: owner-linuxppc-dev@lists.linuxppc.org List-Id: > Do you always use BootX? I've never even tried it... I normally start Linux using BootX from within MacOS. For some reason this seems to work better than using OF to boot. My guess is that the nPower init or the MacOS init sets up the SMP card correctly. The downside to this is that you need a MacOS partition. The upside for me is that I finally found something to do with my old 250 MB hard drive. > Thanks. If you have any modules, could you include them too? I'd > appreciate it. Try to download on of the images from the URL: http://www.CSUA.Berkeley.EDU/~ranga/downloads/linuxPPC/kernels/ All of the images are the same. You should plain vmlinux, a gzip'ed version and a sit.hqx version. As a warning, I will probably get rid of the vmlinux image sometime next week since it is so large. I don't have any modules, *almost* everything is compiled into the kernel. HTH, ----ranga [[ This message was sent via the linuxppc-dev mailing list. Replies are ]] [[ not forced back to the list, so be sure to Cc linuxppc-dev if your ]] [[ reply is of general interest. Please check http://lists.linuxppc.org/ ]] [[ and http://www.linuxppc.org/ for useful information before posting. ]]