From: Rasmus Andersen <rasmus@jaquet.dk>
To: Marcelo Tosatti <marcelo@conectiva.com.br>
Cc: lkml <linux-kernel@vger.kernel.org>
Subject: Re: Linux 2.4.18-pre2
Date: Tue, 8 Jan 2002 22:20:42 +0100 [thread overview]
Message-ID: <20020108222042.A1335@jaquet.dk> (raw)
In-Reply-To: <Pine.LNX.4.21.0201072130170.18722-100000@freak.distro.conectiva>
In-Reply-To: <Pine.LNX.4.21.0201072130170.18722-100000@freak.distro.conectiva>; from marcelo@conectiva.com.br on Mon, Jan 07, 2002 at 09:38:17PM -0200
Hi Marcelo.
This is a resend of a patch I sent you earlier, rediffed. Explanation
below.
---
The following patch makes drivers/char/generic_serial.c check the
return code of copy_{from,to}_user, coverts a cli/sti to
save_flags/cli/restore_flags and does some minor cleanup. It
also makes the rio_linux, serial_tx3912, sh-sci and sx drivers
propagate the copy_xxx_user return codes upwards.
The patch has been blessed by Rogier Wolff, the maintainer.
---
diff -uar linux-2418p2-clean/drivers/char/generic_serial.c linux-2418p2/drivers/char/generic_serial.c
--- linux-2418p2-clean/drivers/char/generic_serial.c Fri Sep 14 00:21:32 2001
+++ linux-2418p2/drivers/char/generic_serial.c Tue Jan 8 22:10:22 2002
@@ -143,7 +143,12 @@
/* Can't copy more? break out! */
if (c <= 0) break;
if (from_user)
- copy_from_user (port->xmit_buf + port->xmit_head, buf, c);
+ if (copy_from_user (port->xmit_buf + port->xmit_head,
+ buf, c)) {
+ up (& port->port_write_sem);
+ return -EFAULT;
+ }
+
else
memcpy (port->xmit_buf + port->xmit_head, buf, c);
@@ -214,8 +219,13 @@
while (1) {
c = count;
- /* This is safe because we "OWN" the "head". Noone else can
- change the "head": we own the port_write_sem. */
+ /* Note: This part can be done without
+ * interrupt routine protection since
+ * the interrupt routines may only modify
+ * shared variables in safe ways, in the worst
+ * case causing us to loop twice in the code
+ * below. See comments below. */
+
/* Don't overrun the end of the buffer */
t = SERIAL_XMIT_SIZE - port->xmit_head;
if (t < c) c = t;
@@ -506,7 +516,7 @@
void gs_shutdown_port (struct gs_port *port)
{
- long flags;
+ unsigned long flags;
func_enter();
@@ -589,6 +599,7 @@
int do_clocal = 0;
int CD;
struct tty_struct *tty;
+ unsigned long flags;
func_enter ();
@@ -604,7 +615,7 @@
* until it's done, and then try again.
*/
if (tty_hung_up_p(filp) || port->flags & ASYNC_CLOSING) {
- interruptible_sleep_on(&port->close_wait);
+ interruptible_sleep_on(&port->close_wait);
if (port->flags & ASYNC_HUP_NOTIFY)
return -EAGAIN;
else
@@ -668,10 +679,11 @@
add_wait_queue(&port->open_wait, &wait);
gs_dprintk (GS_DEBUG_BTR, "after add waitq.\n");
+ save_flags(flags);
cli();
if (!tty_hung_up_p(filp))
port->count--;
- sti();
+ restore_flags(flags);
port->blocked_open++;
while (1) {
CD = port->rd->get_CD (port);
@@ -1003,7 +1015,8 @@
{
struct serial_struct sio;
- copy_from_user(&sio, sp, sizeof(struct serial_struct));
+ if (copy_from_user(&sio, sp, sizeof(struct serial_struct)))
+ return(-EFAULT);
if (!capable(CAP_SYS_ADMIN)) {
if ((sio.baud_base != port->baud_base) ||
@@ -1033,7 +1046,7 @@
* Generate the serial struct info.
*/
-void gs_getserial(struct gs_port *port, struct serial_struct *sp)
+int gs_getserial(struct gs_port *port, struct serial_struct *sp)
{
struct serial_struct sio;
@@ -1055,7 +1068,10 @@
if (port->rd->getserial)
port->rd->getserial (port, &sio);
- copy_to_user(sp, &sio, sizeof(struct serial_struct));
+ if (copy_to_user(sp, &sio, sizeof(struct serial_struct)))
+ return -EFAULT;
+ return 0;
+
}
diff -uar linux-2418p2-clean/drivers/char/rio/rio_linux.c linux-2418p2/drivers/char/rio/rio_linux.c
--- linux-2418p2-clean/drivers/char/rio/rio_linux.c Thu Oct 25 22:53:47 2001
+++ linux-2418p2/drivers/char/rio/rio_linux.c Tue Jan 8 22:10:22 2002
@@ -742,7 +742,7 @@
case TIOCGSERIAL:
if ((rc = verify_area(VERIFY_WRITE, (void *) arg,
sizeof(struct serial_struct))) == 0)
- gs_getserial(&PortP->gs, (struct serial_struct *) arg);
+ rc = gs_getserial(&PortP->gs, (struct serial_struct *) arg);
break;
case TCSBRK:
if ( PortP->State & RIO_DELETED ) {
diff -uar linux-2418p2-clean/drivers/char/serial_tx3912.c linux-2418p2/drivers/char/serial_tx3912.c
--- linux-2418p2-clean/drivers/char/serial_tx3912.c Fri Nov 9 23:01:21 2001
+++ linux-2418p2/drivers/char/serial_tx3912.c Tue Jan 8 22:10:22 2002
@@ -673,7 +673,7 @@
case TIOCGSERIAL:
if ((rc = verify_area(VERIFY_WRITE, (void *) arg,
sizeof(struct serial_struct))) == 0)
- gs_getserial(&port->gs, (struct serial_struct *) arg);
+ rc = gs_getserial(&port->gs, (struct serial_struct *) arg);
break;
case TIOCSSERIAL:
if ((rc = verify_area(VERIFY_READ, (void *) arg,
diff -uar linux-2418p2-clean/drivers/char/sh-sci.c linux-2418p2/drivers/char/sh-sci.c
--- linux-2418p2-clean/drivers/char/sh-sci.c Mon Oct 15 22:36:48 2001
+++ linux-2418p2/drivers/char/sh-sci.c Tue Jan 8 22:10:22 2002
@@ -919,7 +919,7 @@
case TIOCGSERIAL:
if ((rc = verify_area(VERIFY_WRITE, (void *) arg,
sizeof(struct serial_struct))) == 0)
- gs_getserial(&port->gs, (struct serial_struct *) arg);
+ rc = gs_getserial(&port->gs, (struct serial_struct *) arg);
break;
case TIOCSSERIAL:
if ((rc = verify_area(VERIFY_READ, (void *) arg,
diff -uar linux-2418p2-clean/drivers/char/sx.c linux-2418p2/drivers/char/sx.c
--- linux-2418p2-clean/drivers/char/sx.c Tue Jan 8 22:09:24 2002
+++ linux-2418p2/drivers/char/sx.c Tue Jan 8 22:10:22 2002
@@ -1817,7 +1817,7 @@
case TIOCGSERIAL:
if ((rc = verify_area(VERIFY_WRITE, (void *) arg,
sizeof(struct serial_struct))) == 0)
- gs_getserial(&port->gs, (struct serial_struct *) arg);
+ rc = gs_getserial(&port->gs, (struct serial_struct *) arg);
break;
case TIOCSSERIAL:
if ((rc = verify_area(VERIFY_READ, (void *) arg,
Only in linux-2418p2/drivers/char: sx.c~
diff -uar linux-2418p2-clean/include/linux/generic_serial.h linux-2418p2/include/linux/generic_serial.h
--- linux-2418p2-clean/include/linux/generic_serial.h Fri Sep 7 18:28:38 2001
+++ linux-2418p2/include/linux/generic_serial.h Tue Jan 8 22:10:22 2002
@@ -12,9 +12,6 @@
#ifndef GENERIC_SERIAL_H
#define GENERIC_SERIAL_H
-
-
-
struct real_driver {
void (*disable_tx_interrupts) (void *);
void (*enable_tx_interrupts) (void *);
@@ -98,7 +95,7 @@
struct termios * old_termios);
int gs_init_port(struct gs_port *port);
int gs_setserial(struct gs_port *port, struct serial_struct *sp);
-void gs_getserial(struct gs_port *port, struct serial_struct *sp);
+int gs_getserial(struct gs_port *port, struct serial_struct *sp);
void gs_got_break(struct gs_port *port);
extern int gs_debug;
Regards,
Rasmus
next prev parent reply other threads:[~2002-01-08 21:21 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2002-01-07 23:38 Linux 2.4.18-pre2 Marcelo Tosatti
2002-01-08 4:23 ` netfilter oops (Was: Re: Linux 2.4.18-pre2) CaT
2002-01-08 14:04 ` Marcelo Tosatti
2002-01-12 9:56 ` CaT
2002-01-08 21:20 ` Rasmus Andersen [this message]
-- strict thread matches above, loose matches on Subject: below --
2002-01-08 3:23 Linux 2.4.18-pre2 Louis Garcia
2002-01-08 22:02 ` Erik Andersen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20020108222042.A1335@jaquet.dk \
--to=rasmus@jaquet.dk \
--cc=linux-kernel@vger.kernel.org \
--cc=marcelo@conectiva.com.br \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.