From mboxrd@z Thu Jan 1 00:00:00 1970 Message-Id: <200211290048.SAA31687@lists.linuxppc.org> From: "=?GB2312?Q?=D3=DA=E6=BA?=" To: "linuxppc-embedded@lists.linuxppc.org" Subject: Re: zynx zx212 dual-port ethernet card Mime-Version: 1.0 Content-Type: text/plain Date: Fri, 29 Nov 2002 8:52:18 +0800 Sender: owner-linuxppc-embedded@lists.linuxppc.org List-Id: The start information is list below: ////////////////////////////////// Copyright Motorola Inc. 1988 - 2001, All Rights Reserved PPC5 Debugger/Diagnostics Release Version 1.3 - 04/27/2001 RM01 COLD Start Local Memory Found =20000000 (&536870912) MPU Clock Speed =400Mhz BUS Clock Speed =100Mhz Reset Vector Location : ROM Bank B Mezzanine Configuration: Single-MPU Current 60X-Bus Master : MPU0 Idle MPU(s) : NONE L2Cache: 2048KB, 200Mhz Initializing System Memory (DRAM)... L2Cache: 2048KB, 200Mhz System Memory: 512MB, ECC Enabled (ECC-Memory Detected) SelfTest/Boots about to Begin... Press at anytime to Abort ALL NetBoot about to Begin... Press to Bypass, to Continue Network Booting from: I82559, Controller 0, Device 0 Device Name: /pci@fec00000/pci8086,1209@e,0:0,0 Loading: vmlinuz-motorola-lopec Client IP Address = 192.168.201.3 Server IP Address = 192.168.201.1 Gateway IP Address = 0.0.0.0 Subnet IP Address Mask = 255.255.255.0 Boot File Name = vmlinuz-motorola-lopec Argument File Name = Network Boot File load in progress... To abort hit Bytes Received =&784800, Bytes Loaded =&784800 Bytes/Second =&392400, Elapsed Time =2 Second(s) Residual-Data Located at: $1FED16DC loaded at: 00005400 000C65BC relocated to: 00800000 008C11BC zimage at: 00805A00 008BD53E avail ram: 00400000 00800000 Linux/PPC load: ip=on Uncompressing Linux...done. Now booting the kernel ///////////////////////////// Have you solved your problem now? >Sir, I am having a similar issue with an Intel network board on an MCP750 >board. How far does the kernel get, where does it stop? > I'm porting hardhat linux v2.1 on my motorola lopec mpc7410 board with a zynx zx212 dual-port ethernet card on it.The problem is that the kernel can't start up with the ethernet card on,while without it everything is perfect.Since zx212 is compatible with 21143,I build the kernel with the "tulip" option on.It should be no problem,but it happened.Can anybody tell me the reason? > 　　　　　　　　yuj@mail.ndsc.com.cn > 　　　　　　　　　　2002-11-14 > > 　　　　　　　　yuj@mail.ndsc.com.cn 　　　　　　　　　　2002-11-26 ** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/