From: Jacek Kawa <jfk@zeus.polsl.gliwice.pl>
To: linux-kernel@vger.kernel.org
Cc: mdharm-usb@one-eyed-alien.net
Subject: 2.4.20/2.4.21-pre3 usb Oops
Date: Wed, 15 Jan 2003 12:12:35 +0100 [thread overview]
Message-ID: <20030115111234.GA1322@finwe.eu.org> (raw)
Hello!
I've got ide disk connected as usb-storage device.
Oops is reproductable (output from ksymoops below).
I had to copy it from screen (I hope effects are
reliable).
How I reproduced it:
--------------------
I loaded usb-storage (which loaded sd_mod), then sg,
made copy of /proc/ksyms then tried to fdisk /dev/sda.
System:
-------
I've got 2.4.20 with preempt, but effect is similar
while running 2.4.21-pre3. I'm quite sure I could use
it with 2.4.17/18.
While I was composing this message and tried to disconnect
mentioned device system froze.
config: http://zeus.polsl.gliwice.pl/~jfk/kernel/2.4/config-2.4.20+p.gz
dmesg: http://zeus.polsl.gliwice.pl/~jfk/kernel/dmesg.gz
Logs (not 'directly' oops related)
----------------------------------
/etc/hotplug/usb.agent: Setup usb-storage for USB product 55aa/103/904
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
usb-uhci.c: interrupt, status 3, frame# 245
usb_control/bulk_msg: timeout
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Model: Rev:
Type: Direct-Access ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
----------------------------------
<Output from ksymoops:>
ksymoops 2.4.8 on i686 2.4.20+p. Options used
-V (default)
-k ./ksyms (specified)
-l /proc/modules (default)
-o /lib/modules/2.4.20+p (specified)
-m /boot/System.map-2.4.20+p (specified)
Warning (compare_ksyms_lsmod): module input is in lsmod but not in ksyms, probably no symbols exported
Warning (compare_ksyms_lsmod): module snd-mixer-oss is in lsmod but not in ksyms, probably no symbols exported
Warning (compare_ksyms_lsmod): module snd-pcm-oss is in lsmod but not in ksyms, probably no symbols exported
Error (compare_ksyms_lsmod): module sg is in ksyms but not in lsmod
Oops: 0000d
CPU: 0 <EIP: 0010:[<c012e548>] Not tainted
EFLAGS: 00010002
eax: 01e27c98 ebx: 6f732e78 ecx: 00000000 edx: c100001c
esi: 00000000 edi: 00000206 ebp: 00000000 esp: c8a03e84
ds: 0018 es: 0018 ss: 0018
Process usb.agent (pid 1560 stackpage=c8a03000)
Stack: cfd54980 00000000 cff2ada0 00000000 c01b8b07 6f732e78 cff24800 00000000
cff2ada0 00000000 00000000 d081e159 00000001 cfd54980 c01b7eec cff24800
cff24800 00000000 d081eadf cff24800 c12e587c c12e5860 00000000 00000000
Call Trace: [<c01b8b07>] [<d081e159>] [<c01b7eec>] [<d081eadf>] [<d081ebca>] [<c010811d>] [<c0108311>] [<c0121274>] [<c0106d7b>]
Code: 2b 59 0c 89 d8 31 d2 f7 76 18 89 c3 8b 41 14 89 44 99 18 89
Using defaults from ksymoops -t elf32-i386 -a i386
>>edx; c100001c <_end+d371c4/10548208>
>>esp; c8a03e84 <_end+873b02c/10548208>
Trace; c01b8b07 <usb_destroy_configuration+163/1b4>
Trace; d081e159 <[usb-uhci]uhci_free_dev+2d/34>
Trace; c01b7eec <usb_free_dev+24/3c>
Trace; d081eadf <[usb-uhci]process_urb+243/254>
Trace; d081ebca <[usb-uhci]uhci_interrupt+da/154>
Trace; c010811d <handle_IRQ_event+31/5c>
Trace; c0108311 <do_IRQ+b9/118>
Trace; c0121274 <sys_rt_sigprocmask+1f0/234>
Trace; c0106d7b <system_call+33/38>
Code; 00000000 Before first symbol
00000000 <_EIP>:
Code; 00000000 Before first symbol
0: 2b 59 0c sub 0xc(%ecx),%ebx
Code; 00000003 Before first symbol
3: 89 d8 mov %ebx,%eax
Code; 00000005 Before first symbol
5: 31 d2 xor %edx,%edx
Code; 00000007 Before first symbol
7: f7 76 18 divl 0x18(%esi)
Code; 0000000a Before first symbol
a: 89 c3 mov %eax,%ebx
Code; 0000000c Before first symbol
c: 8b 41 14 mov 0x14(%ecx),%eax
Code; 0000000f Before first symbol
f: 89 44 99 18 mov %eax,0x18(%ecx,%ebx,4)
Code; 00000013 Before first symbol
13: 89 00 mov %eax,(%eax)
<0> Kernel panic: Aiee, killing interrupt handler!
3 warnings and 1 error issued. Results may not be reliable.
Jacek
--
Jacek Kawa
next reply other threads:[~2003-01-15 11:03 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2003-01-15 11:12 Jacek Kawa [this message]
2003-01-15 19:43 ` 2.4.20/2.4.21-pre3 usb Oops Jacek Kawa
2003-01-15 23:33 ` Greg KH
2003-01-16 17:14 ` Jacek Kawa
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20030115111234.GA1322@finwe.eu.org \
--to=jfk@zeus.polsl.gliwice.pl \
--cc=linux-kernel@vger.kernel.org \
--cc=mdharm-usb@one-eyed-alien.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.