From: Manish Lachwani <m_lachwani@yahoo.com>
To: Bryan Andersen <bryan@bogonomicon.net>
Cc: linux-kernel@vger.kernel.org
Subject: Re: FW: PDC202XX DMA loss in 2.4.21-pre3-ac4
Date: Sat, 25 Jan 2003 23:15:24 -0800 (PST) [thread overview]
Message-ID: <20030126071524.57299.qmail@web20509.mail.yahoo.com> (raw)
In-Reply-To: <3E33855B.60706@bogonomicon.net>
The "Hardware ECC Recovered" indicates the number of
ECC errors corrected in the drive. Do one thing. Try
to swap the drive with the drive on another ATA cable.
So, swap /dev/hde with /dev/hda (or whatever)
physically and check if the error follows the drive or
the ATA cable.
If it follows the drive, you may have to replace the
drive. Additionally, from the SMART error log #5:
00 04 01 0b 4f c2 e0 51 279972
indicates an aborted command (0x04) at the sector
0x0c24f0b. Try to read from that sector doing a "dd"
and see if the dd aborts too.
If the problem follows the drive, you should then run
a DOS based diagnostic utility (from the Maxtor site)
to determine if there are physical defects on the
drive ...
Thanks
Manish
--- Bryan Andersen <bryan@bogonomicon.net> wrote:
> Manish Lachwani wrote:
> > 0xd0 indicates that the driver aborted the
> command.
> > Can you try to get the SMART data from the drive
> using
> > smartctl?
> >
> > use "smartctl -e /dev/hdX" to enable SMART
> collection
> >
> > use "smartctl -a /dev/hdX" to collect the SMART
> data
>
> Ok, so where do I find information on how to decode
> this?
>
> # smartctl -a /dev/hde
> Device: Maxtor 4G160J8 Supports ATA Version 6
> Drive supports S.M.A.R.T. and is enabled
> Check S.M.A.R.T. Passed.
>
> General Smart Values:
> Off-line data collection status: (0x00) Offline data
> collection activity was
> never
> started
>
> Self-test execution status: ( 0) The previous
> self-test routine
> completed
> without
> error or no self-test
> has ever
> been run
>
> Total time to complete off-line
> data collection: ( 30) Seconds
>
> Offline data collection
> Capabilities: (0x1b)SMART EXECUTE
> OFF-LINE IMMEDIATE
> Automatic
> timer ON/OFF support
> Suspend
> Offline Collection upon new
> command
> Offline
> surface scan supported
> Self-test
> supported
>
> Smart Capablilities: (0x0003) Saves SMART
> data before entering
>
> power-saving mode
> Supports
> SMART auto save timer
>
> Error logging capability: (0x01) Error
> logging supported
>
> Short self-test routine
> recommended polling time: ( 2) Minutes
>
> Extended self-test routine
> recommended polling time: ( 103) Minutes
>
> Vendor Specific SMART Attributes with Thresholds:
> Revision Number: 16
> Attribute Flag Value Worst
> Threshold Raw Value
> ( 3)Spin Up Time 0x0027 252 252
> 063 0
> ( 4)Start Stop Count 0x0032 253 253
> 000 0
> ( 5)Reallocated Sector Ct 0x0033 253 253
> 063 0
> ( 6)Read Channel Margin 0x0001 253 253
> 100 0
> ( 7)Seek Error Rate 0x000a 253 252
> 000 0
> ( 8)Seek Time Preformance 0x0027 244 244
> 187 36736
> ( 9)Power On Hours 0x0032 253 253
> 000 4341
> ( 10)Spin Retry Count 0x002b 252 252
> 223 0
> ( 11)Calibration Retry Count 0x002b 252 252
> 223 0
> ( 12)Power Cycle Count 0x0032 253 253
> 000 43
> (192)Power-Off Retract Count 0x0032 253 253
> 000 0
> (193)Load Cycle Count 0x0032 253 253
> 000 0
> (194)Temperature 0x0032 253 253
> 000 0
> (195)Hardware ECC Recovered 0x000a 253 252
> 000 221
> (196)Reallocated Event Count 0x0008 253 253
> 000 0
> (197)Current Pending Sector 0x0008 253 253
> 000 0
> (198)Offline Uncorrectable 0x0008 253 253
> 000 0
> (199)UDMA CRC Error Count 0x0008 199 199
> 000 0
> (200)Unknown Attribute 0x000a 253 252
> 000 0
> (201)Unknown Attribute 0x000a 253 252
> 000 0
> (202)Unknown Attribute 0x000a 253 252
> 000 0
> (203)Unknown Attribute 0x000b 253 252
> 180 0
> (204)Unknown Attribute 0x000a 253 252
> 000 0
> (205)Unknown Attribute 0x000a 253 252
> 000 0
> (207)Unknown Attribute 0x002a 252 252
> 000 0
> (208)Unknown Attribute 0x002a 252 252
> 000 0
> (209)Unknown Attribute 0x0024 253 253
> 000 0
> ( 99)Unknown Attribute 0x0004 253 253
> 000 0
> (100)Unknown Attribute 0x0004 253 253
> 000 0
> (101)Unknown Attribute 0x0004 253 253
> 000 0
> SMART Error Log:
> SMART Error Logging Version: 1
> Error Log Data Structure Pointer: 05
> ATA Error Count: 8
> Non-Fatal Count: 0
>
> Error Log Structure 1:
> DCR FR SC SN CL SH D/H CR Timestamp
> 00 db 00 00 4f c2 00 b0 201
> 00 d8 00 00 4f c2 00 b0 201
> 00 da 00 00 4f c2 00 b0 201
> 00 d9 00 00 4f c2 00 b0 201
> 00 fe 00 00 00 00 00 ef 201
> 00 04 50 42 97 23 00 51 5
>
> Error Log Structure 2:
> DCR FR SC SN CL SH D/H CR Timestamp
> 08 00 80 2a 4e 8a e0 25 458636
> 08 00 80 aa 4e 8a e0 25 458636
> 08 00 80 2a 4f 8a e0 25 458636
> 08 00 80 aa 4f 8a e0 25 458636
> 08 d0 01 00 4f c2 e0 b0 459147
> 00 04 01 0b 4f c2 e0 51 279972
>
> Error Log Structure 3:
> DCR FR SC SN CL SH D/H CR Timestamp
> 08 00 80 aa 4e 8a e0 25 458636
> 08 00 80 2a 4f 8a e0 25 458636
> 08 00 80 aa 4f 8a e0 25 458636
> 08 d0 01 00 4f c2 e0 b0 459147
> 08 d1 01 01 4f c2 e0 b0 459147
> 00 04 01 0b 4f c2 e0 51 279972
>
> Error Log Structure 4:
> DCR FR SC SN CL SH D/H CR Timestamp
> 08 00 80 2a 4f 8a e0 25 458636
> 08 00 80 aa 4f 8a e0 25 458636
> 08 d0 01 00 4f c2 e0 b0 459147
> 08 d1 01 01 4f c2 e0 b0 459147
> 08 d0 01 00 4f c2 e0 b0 459148
> 00 04 01 0b 4f c2 e0 51 279972
>
> Error Log Structure 5:
> DCR FR SC SN CL SH D/H CR Timestamp
> 08 00 80 aa 4f 8a e0 25 458636
> 08 d0 01 00 4f c2 e0 b0 459147
> 08 d1 01 01 4f c2 e0 b0 459147
> 08 d0 01 00 4f c2 e0 b0 459148
> 08 d1 01 01 4f c2 e0 b0 459148
> 00 04 01 0b 4f c2 e0 51 279972
>
>
> - Bryan
>
__________________________________________________
Do you Yahoo!?
Yahoo! Mail Plus - Powerful. Affordable. Sign up now.
http://mailplus.yahoo.com
next prev parent reply other threads:[~2003-01-26 7:06 UTC|newest]
Thread overview: 11+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <233C89823A37714D95B1A891DE3BCE5202AB1D07@xch-b.win.zambeel.com>
2003-01-25 20:34 ` FW: PDC202XX DMA loss in 2.4.21-pre3-ac4 Manish Lachwani
2003-01-26 6:51 ` Bryan Andersen
2003-01-26 7:15 ` Manish Lachwani [this message]
2003-01-26 8:13 ` Andre Hedrick
2003-01-26 8:27 ` Manish Lachwani
2003-01-26 8:48 ` Andre Hedrick
2003-01-26 9:10 ` Manish Lachwani
2003-01-26 9:14 ` Andre Hedrick
[not found] <233C89823A37714D95B1A891DE3BCE5202AB1D12@xch-b.win.zambeel.com>
2003-01-26 9:42 ` Andre Hedrick
2003-01-26 11:24 ` Bryan Andersen
2003-01-26 21:27 ` Andre Hedrick
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20030126071524.57299.qmail@web20509.mail.yahoo.com \
--to=m_lachwani@yahoo.com \
--cc=bryan@bogonomicon.net \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.