Re: 2.5.62-mm3 - no X for me

[Zilvinas Valinskas <zilvinas@gemtek.lt>]

On Mon, Feb 24, 2003 at 01:26:53PM +0100, Helge Hafting wrote:
> 2.5.62-mm3 boots up fine, but won't run X.  Something goes
> wrong switching to graphics so my monitor says "no signal"
> 
> Using radeonfb:
> Switching to the framebuffer console almost works, but
> the video mode is messed up so parts of the text appear
> all over the screen.  Switching back to X again shows
> X in a very messed up video mode, some sort
> of resolution mismatch.
> 
> Using plain vga console:
> Nothing happens on the screen after I get "no signal",
> console switching has no effect.  Sync&Reboot via
> sysrq works though.
> 
> The kernel uses UP, preempt, no module support, devfs configured
> but not used.
> 
> Hardware:
> 2.4GHz P4, 512M
> 01:00.0 VGA compatible controller: ATI Technologies Inc Radeon VE QY
> 00:01.0 PCI bridge: Silicon Integrated Systems [SiS] 5591/5592 AGP

Same is here. Radeon too, only it is Radeon M7 LY 8)
> 
> Helge Hafting
> 
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/