From mboxrd@z Thu Jan 1 00:00:00 1970 From: khali@linux-fr.org (Jean Delvare) Date: Thu, 19 May 2005 06:24:17 +0000 Subject: fan2 readout on Chaintech MB Message-Id: <20030917225126.420740fc.khali@linux-fr.org> List-Id: References: <200308310230.14115.ljubo108@vip.hr> In-Reply-To: <200308310230.14115.ljubo108@vip.hr> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org > I have been trying to use recent CVS version. I update CVS whenever I > can with cvs update -d, I did not updated just lm90 or any file > separately. > > My install procedure goes like this(Mandrake 9.1): > 1. vanilla 2.4.22 kernel > 2. con kolivas 2.4.22-ck2 patch set > 3. patching kernel with i2c and lm_sensors > 4. loading my kernel config file > 5. compiling and installing kernel > 6. reboot > 7. cd into lm_sensors, make and make install > 8. /prog/detect/sensors-detect > 9. then I edit modules and modules.conf as suggested > 10. reboot > 11. Gkrellm, KSensors or just sensors > > I have used con kolivas ck1 patchset on previous lm_sensors config. What's inside that patchset? Anything related to either ACL or GRSEC? Can you remember all changes that occured between when "sensors -s" was working OK, and when it wasn't anymore? I'd appreciate if you could take all the steps back to a state where "sensors -s" works again. If we could isolate the problem, we would have a chance to understand it. > Unfortunately I have had some problems with 166MHz FSB jumper on my > motherboard and I have RMA the board. I thing that replacment/new > board will arrive next week so I can't do more testing now :-(( No problem, I am busy myself and most of the lm_sensors developers also are. > As soone as I get it working again I will do more testing. OK, thanks. -- Jean Delvare http://www.ensicaen.ismra.fr/~delvare/